2Click Save Changes.
3If the Encapsulation setting that you entered starts with either PPPoE or PPPoA: Click Write Settings to Flash and Reboot, and Confirm. Once the process is complete, the X5v’s LINK light remain on steady (this should take about 15 seconds). If it doesn’t, go to the Connection Troubleshooting Tips on page 77.
If the Encapsulation setting that you entered starts with either 1483 Bridged or 1483 Routed: You must check now to make sure that your IP Addressing is correctly set. Go to page 15.
4Go to your Web Browser (i.e., Internet Explorer or Netscape Navigator) and try to connect to a familiar Web address.
5If you connect successfully, your installation is complete and you’re ready to browse the web! Continue with Setting Up VoIP Service on page 16.
If you do not connect successfully, refer to the Troubleshooting Appendix on page 77.
Chapter 1: Installation Instructions | 13 |