Compaq FTAM Responder Diagnostic Messages | General FTAM Diagnostic Messages |
Effect. The responder aborts the association. If the data buffer capacity was exceeded for the reason given under “Cause,” the Further Details field contains the message smaller PDU or larger MSL needed.
Recovery. If the Further Details field indicates that a smaller PDU or a larger MSL is needed, the application or FTAM user should decrease the number of strings sent in one PDU. This can be done either by sending a smaller number of strings per PDU or by sending larger strings. Sending larger strings may require increasing the value of the
Otherwise, the application or FTAM user should retry the operation. This can be a transient condition. If the condition persists, the Compaq problem solver should trace the responder and follow the standard procedures at the Compaq site for contacting the appropriate support personnel. These procedures might involve contacting the local Compaq support analyst. For details on how to trace the responder, refer to the SCF Reference Manual for FTAM and APLMGR and the Compaq PTrace Reference Manual.
7
Unspecific initiator error
Cause. The responder received a
Effect. This is an
Recovery. No action is necessary.
8
Subsequent error
Cause. In a grouped request, one of the requests after the one on which the responder returns this diagnostic message has encountered an error condition.
Effect. The responder rejects the grouped request.
Recovery. The application programmer or FTAM user should determine which request in the group failed and correct the problem.
9
Temporal insufficiency of resources
Cause. The responder has attempted to allocate memory for a data control block, but the memory table does not have sufficient space to satisfy the request.
Effect. The responder aborts the association.
