Compaq OSI/FTAM D43, OSI/APLMGR D43 manual 3027, 3028, 3029, 3030

Compaq FTAM Responder Diagnostic Messages Selection-Related Diagnostic Messages

3027

Bad attribute value

Cause. An invalid value was detected in an attribute on the create or select service. This message is caused if the filename attribute cannot be decoded or is invalid for the file system.

Effect. The service fails.

Recovery. The application or FTAM user should correct the value for that attribute and retry. For possible limitations on attribute values that the Compaq FTAM responder supports, see Section 4.

3028

Requested access violates permitted actions

Cause. The requested access specified on a select request was inconsistent with the contents-type attribute specified when the file was created. The responder can return this error in two cases:

•nAny file other than an FTAM-2 file was selected for insert access. Insert access is allowed only on FTAM-2 files.

•nAn FTAM-2 file was selected for replace or extend access, or both. Replace and extend access is not allowed on FTAM-2 files.

Effect. The service fails.

Recovery. The application or FTAM user should retry with requested-access values that are valid for the contents type.

3029

Functional unit not available for requested access

Cause. The negotiated functional units were inconsistent with the requested access type specified on the select or create service.

Effect. The service fails.

Recovery. The application or FTAM user should establish a new association providing the required functional units.

3030

File created but not selected

Cause. The create request succeeded in creating a Guardian file, but the select regime has not been established because the requested access was not correct.

OSI/FTAM Responder Manual—425199-001

A-15