Compaq FTAM Responder Diagnostic Messages |
Effect. The service fails.
Recovery. The application programmer or FTAM user should check the attribute values and determine which attribute the responder does not support, and then retry the request without specifying the unsupported attribute in the create request. If the problem persists, the Compaq problem solver can use the SCF TRACE command and the PTrace utility to troubleshoot the problem. For more information on tracing and troubleshooting, refer to the OSI/FTAM Configuration and Management Manual.
3004
Cause. A file has ceased to exist after being selected. The VFS has received an operating system error 11 in attempting to access a previously selected file.
Effect. The service fails.
Recovery. The application or FTAM user should either retry the operation specifying a file that exists, or try again after the Compaq problem solver has replaced the file.
3005
File already exists
Cause. A create request has been sent with the override parameter set so that file creation fails if the file already exists, and the file already exists in the file system. The CREATE procedure returns an error indicating that the file already exists and cannot be created.
Effect. The service fails.
Recovery. The application or FTAM user should purge the file before attempting to create it, or change the override parameter in the create request to any valid value other than the one specifying that file creation fails if the file already exists.
3006
File cannot be created
Cause. The application or FTAM user attempted to create a directory list
Effect. The file is not created. The Further Details field identifies the related file- system error number.
Recovery. For an interpretation of the
