58 Remote Node Configuration
• CISCO PPP - Cisco PPP options will be used.
2. Compression - Turn on the Stac Compression. The default for
this field is Off.
3. Multiple Link Options: BOD Calculation - Select the
direction of the traffic you wish to calculate in order to
determine when to add or subtract a link. The default for this
field is Transmit or Receive.
4. Multiple Link Options: Base Trans Rate - Select the base
data transfer rate for this Remote Node. This parameter is in
kilobits per second (Kbps). There are two options for this field:
• 64 - Only one channel will be used.
• 128 - Two channels will be used when a packet triggers a
call.
5. Multiple Link Options: Max Trans Rate - Enter the
maximum data transfer rate allowed for this Remote Node. This
parameter is in kilobits per second. There are two options for
this field:
• 64 - At most one channel can be used.
• 128 - A maximum of two channels can be used.
6. Multiple Link Options: Target Utility - Enter the two
thresholds separated by a - for subtracting and adding the
second channel. The default is 32-48.
7. Multiple Link Options: Add Persist - This parameter
specifies the number of seconds there traffic is above the
adding threshold before the Prestige will bring up the second
channel. The default is 5 seconds.
8. Multiple Link Options: Subtract Persist - This parameter
specifies the number of seconds where traffic is below the
subtraction threshold before the Prestige drops the second
channel. The default is 5 seconds.