72 TCP/IP Configuration
Remote Node Se tup
Follow the procedure in Chapter 5 to fill the protocol-
independent parameters in Menu 11, Remote Node Profile. For
the protocol-dependent parameters, follow the instructions
below. If you are configuring the Prestige to receive an
incoming call, you also need to set the default dial-in
parameters in menu 13 (see Chapter 6).
1. Route - Make sure IP is among the protocols in the Route field.
2. IP Address - Enter the IP address of the gateway at the remote
site (in this case, headquarters). If the remote router is using a
different IP address than the one entered here, the Prestige will
drop the call.
3. Edit IP/IPX/Bridge - Press the space bar to change it to Yes
and press Enter to go to the Menu 11.3 - Remote Node
Network Layer Options menu shown below:
Figure 7- 2 Menu 11.3 - Remote Node Network Layer Options
4. Rem IP Address - This will show the IP address you entered
for this Remote Node in the previous menu.
5. Rem IP Subnet Mask - Enter the subnet mask for the remote
network.