ZyXEL Communications 791R 15.2.9 Backup Via Console Port, Step, Step, Table 15-3General Commands for GUI-basedTFTP Clients, Figure 15-3System Maintenance – Backup Configuration

Prestige 791R G.SHDSL Router

	Table 15-3 General Commands for GUI-based TFTP Clients
COMMAND	DESCRIPTION
Host	Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address
	when shipped.
Send/Fetch	Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your
	computer.
Local File	Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
	extension) on your computer.
Remote File	This is the filename on the Prestige. The filename for the firmware is “ras” and for the
	configuration file, is “rom-0”.
Binary	Transfer the file in binary mode.
Abort	Stop transfer of the file.

Refer to section 15.2.5 to read about configurations that disallow TFTP and FTP over WAN.

15.2.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

Step 1. Display menu 24.5 and enter “y” at the following screen.

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

Figure 15-3 System Maintenance – Backup Configuration

Step 2. The following screen indicates that the Xmodem download has started.

You can enter ctrl-x to terminate operation any time.

Starting XMODEM download...

Figure 15-4 System Maintenance – Starting Xmodem Download Screen

15-6 Firmware and Configuration File Maintenance