Prestige 791R G.SHDSL Router

Do not edit filter sets 11 and 12. They are used exclusively by the web

configurator. Any rules you configured in sets 11 and 12 will be erased and

replaced when you apply the web configurator-generated filter rules.

8.5Editing ATM Layer Options

Follow these steps to edit Menu 11.6 – Remote Node ATM Layer Options.

Step 1. In Menu 11.1, move the cursor to the Edit ATM Options then press [SPACE BAR] to toggle and set the value to Yes.

Step 2. Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.

There are two versions of Menu 11.6 for the Prestige, depending on whether you chose VC-basedor LLC- based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.

8.5.1 VC-based Multiplexing (non-PPP Encapsulation)

For VC-basedmultiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1 will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.

Menu 11.6 - Remote Node ATM Layer Options

VPI/VCI (VC-Multiplexing)

VC Options

for IP:

VC Options for Bridge:

VPI #= 0

VPI #= N/A

VCI #= 38

VCI #= N/A

ATM QoS Type= UBR

ATM QoS Type= N/A

Peak Cell Rate (PCR)= 0

Peak Cell Rate (PCR)= N/A

Sustain Cell Rate (SCR)= 0

Sustain Cell Rate (SCR)= N/A

Maximum Burst Size (MBS)= 0

Maximum Burst Size (MBS)= N/A

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Separate VPI and

VCI numbers must

be specified.

Figure 8-11 Menu 11.6 for VC-based Multiplexing (non-PPP Encapsulation)

8-12

Remote Node TCP/IP Configuration