Prestige 791R G.SHDSL Router

Table 8-2 Remote Node Network Layer Options

FIELD

DESCRIPTION

EXAMPLE

 

 

 

NAT

Press [SPACE BAR] and then [ENTER] to select Full Feature if you have

SUA Only

 

multiple public WAN IP addresses for your Prestige.

 

 

Select SUA Only if you have just one public WAN IP address for your

 

 

Prestige. The SMT uses Address Mapping Set 255 (menu 15.1 - see

 

 

section 11.3.1).

 

 

Select None to disable NAT.

 

 

 

 

Address

When Full Feature is selected in the NAT field, configure address

2

Mapping Set

mapping sets in menu 15.1. Select one of the NAT server sets (2-10) in

 

 

menu 15.2 (see the NAT chapter for details) and type that number here.

 

 

When SUA Only is selected in the NAT field, the SMT uses NAT server

 

 

set 1 in menu 15.2 (see the NAT chapter for details).

 

 

 

 

Metric

The metric represents the “cost” of transmission for routing purposes. IP

2

 

routing uses hop count as the cost measurement, with a minimum of 1 for

 

 

directly connected networks. Type a number that approximates the cost

 

 

for this link. The number need not be precise, but it must be between 1

 

 

and 15. In practice, 2 or 3 is usually a good number.

 

Private

This determines if the Prestige will include the route to this remote node in

No

 

its RIP broadcasts. If set to Yes, this route is kept private and not included

 

 

in RIP broadcast. If No, the route to this remote node will be propagated

 

 

to other hosts through RIP broadcasts.

 

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP Direction.

None

 

Options are Both, In Only, Out Only or None.

 

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version.

RIP-1

 

Options are RIP-1, RIP-2Bor RIP-2M.

 

Multicast

IGMP-v1sets IGMP to version 1, IGMP-v2sets IGMP to version 2 and

None

 

None disables IGMP.

 

IP Policies

You can apply up to four IP Policy sets (from 12) by typing in their

3, 4, 5, 6

 

numbers separated by commas. Configure the filter sets in menu 25 first

 

 

(see the IP Policy Routing chapter) and then apply them here.

 

Bridge Options

 

 

 

 

 

Ethernet Addr

See the chapter on Bridging Setup for information on bridging.

 

Timeout (min)

 

 

 

 

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

Remote Node TCP/IP Configuration

8-7