ZyXEL Communications 791R manual 80

Prestige 791R G.SHDSL Router

Table 7-2 Internet Access Setup

FIELD	DESCRIPTION	EXAMPLE
Encapsulation	Press [SPACE BAR] to select the method of encapsulation	ENET ENCAP
	used by your ISP. Choices are PPPoE, PPPoA, RFC 1483
	or ENET ENCAP.
Multiplexing	Press [SPACE BAR] to select the method of multiplexing	LLC-based
	used by your ISP. Choices are VC-basedor LLC-based.
VPI #	Enter the Virtual Path Identifier (VPI) that the telephone	8
	company gives you.
VCI #	Enter the Virtual Channel Identifier (VCI) that the telephone	35
	company gives you.
ATM QoS Type	Press [SPACE BAR] and select CBR (Continuous Bit Rate) to	UBR
	specify fixed (always-on) bandwidth. Select UBR (Unspecified
	Bit Rate) for applications that are non-time sensitive, such as
	e-mail. Select VBR (Variable Bit Rate) for bursty traffic and
	bandwidth sharing with other applications.
Peak Cell Rate	This is the maximum rate at which the sender can send cells.	0
(PCR)	Type the PCR.
Sustain Cell Rate	Sustained Cell Rate is the mean cell rate of a bursty, on-off	0
(SCR)= 0	traffic source that can be sent at the peak rate, and a
	parameter for burst-type traffic. Type the SCR; it must be less
	than the PCR, unless both are set to zero.
Maximum Burst Size	Refers to the maximum number of cells that can be sent at	0
(MBS)= 0	the peak rate. Type the MBS. The MBS must be less than
	65535.
My Login	Configure the My Login and My Password fields for PPPoA	N/A
	and PPPoE encapsulation only. Enter the login name that
	your ISP gives you. If you are using PPPoE encapsulation,
	then this field must be of the form user@domain where
	domain identifies your PPPoE service name.
My Password	Enter the password associated with the login name above.	N/A
ENET ENCAP	Enter the gateway IP address supplied by your ISP when you	N/A
Gateway	are using ENET ENCAP encapsulation.
Idle Timeout	This value specifies the number of idle seconds that elapse	0
	before the Prestige automatically disconnects the PPPoE
	session.

Internet Access 7-7