Chapter 4 Client Mode
Note: The client mode IP address is always the same as the access point mode IP address. If you changed the IP address of your WAP3205 while in access point mode, use this IP address in client mode.
4.5 Client Mode Status Screen
Click 
to open the status screen.
Figure 10 Status: Client Mode
The following table describes the labels shown in the Status screen.
Table 5 Status Screen: Client Mode
LABEL | DESCRIPTION |
Logout | Click this at any time to exit the Web Configurator. |
|
|
Device Information |
|
|
|
Host Name | This is the WAP3205’s model name. |
|
|
Firmware Version | This is the firmware version and the date created. |
|
|
Sys OP Mode | This is the device mode (Section 2.1.1 on page 23) to which the WAP3205 |
| is set - Client Mode. |
|
|
LAN Information |
|
|
|
MAC Address | This shows the LAN Ethernet adapter MAC Address of your device. |
|
|
IP Address | This shows the LAN port’s IP address. |
|
|
IP Subnet Mask | This shows the LAN port’s subnet mask. |
|
|
| 35 |
WAP3205 User’s Guide | |
|
|