Husqvarna 13 AWD, 15 C manual Adjustment of the cutting unit’s parallelism for the Rider

MAINTENANCE

Adjustment of the cutting unit’s parallelism for the Rider 11

1.Check the tyre air pressure. It should be 60 kPa (0,6 kp/cm2).

2.Dismantle the front hood and right-hand fender as described on page 22-23.

3.Vertical adjustment of the cutting unit is made with the adjusting nuts on the back edge of the lift-strut.

4.Raise the cutting unit at the front edge by shortening the lift-strut.

Lower the cutting unit at the front edge by lengthening the lift-strut.

5.Tighten the nuts against each other after the adjustment.

6.On completion of the adjustment the unit’s parallelism should be re-checked.

7.Fit the right-hand fender and the front hood.

Adjusting the parallelism of the Cutting deck on Rider 11 C, Rider 13 C, Rider 13 AWD, Rider 15 C

1.Check that the tyres’ air pressure is 60 kPa (0.6 kp/cm2/8.5 PSI).

2.Remove the front cover and the right-hand wing cover.

3.Loosen the parallelism stay’s nuts.

4.Screw out (extend) the stay to raise the rear edge of the cover. Screw in (shorten) the stay to lower the rear edge of the cover.

5.Tighten the nuts after adjustment.

6.The parallelism should be checked again after the adjustment has been made.

7.Fit the right-hand wing cover and the front cover.

Removing the mulching plug

In order to change a combi unit from the mulching function to a cutting unit with rear ejection, remove the mulching plug located under the cutting unit using the knob.

1.Put the cuttin deck in the service position, see ”Placing in the service position”.

2.Loosen the knob holding the mulching plug and remove the plug.

3.Return the unit to the normal position.

To fit the mulching plug, follow the instructions in the reverse order.

6008-026H

6017-155

6021-023

English – 37