RedMax TR2350S MA2 AIR Filter, MA3 Fuel Filter, MA5 MA6 Muffler, Spark Arrester, Gear Case MA6

Page 17

TR2350S

9. Maintenance

WARNING

• Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury.

MA2

■ AIR FILTER

• The air filter, if clogged, will reduce the

 

 

engine performance. Check and clean

 

the filter element in warm, soapy water

 

as required. Dry completely before

 

installing. If the element is broken or

 

shrunk, replace with a new one. (MA2)

 

(1) air filter

 

 

MA3

■ FUEL FILTER

 

• When the engine runs short of fuel

 

supply, check the fuel cap and the fuel

 

filter for blockage. (MA3)

 

(1) fuel filter

 

 

MA5

MA6

■MUFFLER

WARNING

• Inspect periodically, the muffler for

U

loose fasteners, any damage or

S

corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.

•Note that failing to do so may result in the engine catching on fire.

■SPARK ARRESTER

•The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush.

In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land. (MA5)

(1) spark arrester

■GEAR CASE (MA6)

• The reduction gears are lubricated by

multipurpose, lithium-based grease in

MA4

.025 in

0.655mm

■SPARK PLUG

•Starting failure and mis-firing are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a replacement plug, use the correct type specified by RedMax. (MA4)

•REPLACEMENT PLUG IS A NGK BPMR7A.

the gear case. Supply new grease

every 25 hours of use or more often

depending on the job condition.

• Remove the side bolt in gear case

opposite of grease nipple before

installing new grease to arrange for old

grease to exit.

■INTAKE AIR COOLING VENT

IMPORTANT

•Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.

•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.

TIGHTENING TORQUE:

126~185 in-lbs (14.7~21.6 N.m.)

WARNING

•Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

•When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the brushcutter. Failing to do so could cause the muffler to become overheated, and

US-15

Page 16 Page 18
Image 17
Page 16 Page 18
Contents TR2350S Page TR2350S Contents TR2350S SpecificationsParts location Manufactured Symbols on the machineEmission Control For safe operation Starting the engine Using the productBefore use Avoid noise problem Fuel safetyMaintenance TransportDisposal Connecting Switch Wires SE1 Set upInstalling Handle SE2 Installing Debris GuardFuel WarrantyFuel Gasoline RequirementsMixing Chart HOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OILFor Your Engine LIFE, Avoid Fueling the UnitOperation Cutting Work Line Head Usage Adjusting the Line LengthTrimming Grass and Weeds OP6Maintenance Chart MaintenanceFor safety reasons, do not use metalreinforced line MA1 Refilling Trimming Line MA1MA2 AIR Filter Replacement Plug is a NGK BPMR7AMA3 Fuel Filter MA5 MA6 MufflerStorage MA8 Procedures to be Performed After Every 100 Hours of USEDisposal MA7Optional blade usage Cutting Method OPT7 OPT8 Starting the EngineOPT10 Controlling Blade ThrustHow you can maintain the best control Maintenance BladeOPT11 22, 24-tooth blade Tooth blade Point OPT11Check Probable Causes Action Troubleshooting guideCase 1. Starting failure Mode D’EMPLOI Tables des matieres Differents Types D’AVERTISSEMENT DE CE Mode D’EMPLOIFiche technique Emplacement des piecesMesures DE Lutte Contre LES Emissions Symboles utilises sur la machineEtiquettes d’avertissement sur la machine Consignes de securite Utilisation DU Produit Avant DE Faire Demarrer LE MoteurDemarrage DU Moteur Sécurité carburant TransportRangement Comment eviter les nuisances sonoresEntretien Recommandé deMise au rebut Assemblage Installation DE LA Tete DE Coupe SE3Raccordement DES Fils Electriques Mise EN Place DE LA PoigneeTypes DE Carburants Requis CarburantCarburant Remplissage DU Reservoir ’ANNULATION DE LA Garantie DU Moteur a DeuxTableau DE Melange 50 Eviter Pour Prolonger LA Duree DE VIE DU MoteurFR-12 OP1 Mise EN Marche DU Moteur FonctionnementArret DU Moteur OP3 Reglage Câble D’ACCÉLÉRATEURReglage DE LA Longeur DU FIL DE Coupe OP6 Travail DE Coupe Utilisation DE LA Tete a FILCoupe DE Gazon OU D’HERBES Tableau D’ENTRETIEN MA1 Remplacement DU FIL DE Coupe MA1Entretien MA2 Filtre a AIR SilencieuxMA3 Filtre a Carburant Bougie D’ALLUMAGE MA5 MA6Cylindre Ouïe d’entrée d’air de refroidissement arrière RangementMise au rebut Choisir LA Lame Utilisation de la lame optionnelleMise EN Place DE LA Lame Equilibrage DE LA MachineMethode DE Coupe OPT7 OPT8 OPT9Fonctionnement Controle DES Coups DE ReculEntretien Lame Comment conserver le meilleur contrôle de la machineVerification Causes Probables Action Guide de localisation des pannesPage Desbrozador Advertencias Contenidas EN EL Manual ContenidoTR2301S Situación de las piezasEspecificaciohes Control DE Emisiones Etiqueta de advertencia en la máquinaSímbolos presentes en la máquina Instrucciones de seguridad Arranque DEL Motor Antes DE Arrancar LA MáquinaUSO DEL Producto Cómo evitar problemas de ruidoTransporte Seguridad en el uso del combusibleMantenimiento Para la protección contra las vibracionesEliminación Montaje Requerimientos de la Gasolina CombustibleCombustible Cuadro DE Mezcla Anulará Lagarantía DEL Motor DE DOS Tiempos RedMaxPreste atención en la agitación Abastecimiento DE LA UnidadVacíe del carburador el combustible compuesto OP1 Arranque DEL Motor UsoCómo Parar EL Motor OP2 Ajuste Cable DEL AceleradorAjuste DE LA Longitud DE LA Línea OP6 Trabajo DE Corte USO DEL Cabezal CortadorDesbroce DE Hierbas Y Maleza MA1 Rellenado DE LA Línea DE Desbroce MA1 MantenimientoTabla DE Mantenimiento MA2 Filtro DE AireMA3 Filtro DE Combustible SilenciadorEliminación AlmacenamientoMA8 Procedimientos a Realizar Cada 100 Horas DE USO Cilindro Toma de aire de refrigeración posteriorPAR Torsor Uso de hoja opcionalElija LA Hoja Monte LA HojaUSO Método DE CorteControl DEL Contragolpe DE LA Hoja Qué causa el contragolpeCuál es la mejor forma de mantener el control Cómo se puede reducir la posibilidad de contragolpe?Mantenimiento Hoja Hoja de 22 y 24 dientes Hoja de 8 dientes Hoja de 4 dientesComprobar Posibles Causas Acción 13. Guía de localización y solución de problemasPage Nota Parts listRemarque Drive Unit TR2350S S/N 90200101 and up Key# Part Number Description Qty Optional Blade & AccessoriesPart Number Description Qty Engine Unit TR2350S S/N 90200101 and up Cylinder Zenoah AMERICA, INC

TR2350S specifications

The RedMax TR2350S is a high-performance trimmer designed for both professional landscapers and homeowners who seek efficiency and reliability in their gardening tools. This robust machine showcases the perfect combination of power and versatility, making it an indispensable asset in any landscaping arsenal.

One of the standout features of the TR2350S is its powerful 23.6cc engine, which delivers exceptional performance while ensuring fuel efficiency. The engine is designed with advanced technologies to minimize emissions, aligning with modern environmental standards while maintaining robust power output. This ensures that users can tackle even the toughest trimming tasks without compromising on performance or contributing to pollution.

The TR2350S also features an innovative Easy Start system, which significantly reduces the effort required to start the engine. This user-friendly technology allows for a hassle-free experience, especially important for professionals who need to start up quickly and efficiently throughout their workday.

The trimmer’s ergonomic design enhances comfort during extended periods of use. It features a curved shaft that is not only lightweight but also well-balanced, reducing operator fatigue. The soft-grip handles provide additional comfort and control, allowing users to maneuver the trimmer easily around various landscaping obstacles.

Another notable aspect of the RedMax TR2350S is its dual-line cutting system, which offers a clean and efficient cut. The trimmer comes equipped with a bump feed head, ensuring that the cutting line is automatically released with a simple tap on the ground. This feature allows users to keep working without the need to stop and adjust the line manually.

Safety is also a priority in the design of the TR2350S. The unit incorporates various safety features, including a guard that helps protect the operator from debris and an easy-to-access throttle control that keeps the user in command of the trimmer’s performance.

In conclusion, the RedMax TR2350S is a versatile, powerful, and user-friendly trimmer that caters to both professionals and homeowners. Its innovative technologies, comfort-enhancing design, and safety features make it a leading choice for those looking to efficiently maintain their outdoor spaces. With the TR2350S, users can expect reliability and performance that meets the demands of any trimming job.
Top Page Image Contents