Athena Technologies 16C instruction manual Input Menu, Display Parameter Selection

Page 19

Input Menu

NOTE: FOR A MORE DETAILED DESCRIPTION OF MENU

PARAMETERS, REFER TO THE GLOSSARY

WHICH BEGINS ON PAGE 64.

The first parameter that needs to be set is Input Type. The remaining Input Menu parameters will change, depending upon whether a linear input type or a temperature input type is selected. Other menu param- eters related to the sensor range may also change. After selecting your Input Type, refer to the corresponding section on page 16 for the remainder of the Input Menu parameters.

Input Menu

Display Parameter	Selection
Input Type	Type J thermocouple
	Type B thermocouple
	Type C thermocouple
	Type E thermocouple
	Type K thermocouple
	Type N thermocouple
	Type NIC thermocouple
	Type NNM thermocouple
	Type R thermocouple
	Type S thermocouple
	Type T thermocouple
	Platinel II thermocouple
	100 ohm
	platinum RTD

15

Image 19

Contents 16C Introduction Precautions FeaturesSafety Warning Contents Installation Mounting DimensionsContact Identification WiringLead resistance. For long runs Wire RTDs should be used Make sure that you are using Appropriate thermocoupleRTDs. Connect 2-wire RTDs Wire, if necessary, to minimizeA 120/240 Vac relay, but normally closed output 2 only Output TypesRaise Key Menu Access KeyMode/Enter Key Lower KeySecurity Level, Menu System, and Operating Mode Power OnSecurity Levels Security Levels and Access RestrictionsManual Operating ModesMenu System Overview Been installed. Pressing the Menu Access key indexesMenu System Overview Menu System Chart of Series 16C Menu System Security Levels On Next See options manual for parameter selections Descriptions Menus and ParameterDisplay Parameter Selection Input MenuJMPØ2 Output Menu Display MenuDisplay Parameter Output Menu Control Menu Output Type Recommended Setting secondsParameter Selection On/Off Output TypeBelow alarm setting Setpoint. High process alarmDeviation Alarm Alarm Output Type Autotune Damping Menu Recipe Ramp/ Soak Menu Eter should be set to which will disable itPower Fail Resume Supervisor Menu Options Menu Calibration MenuTo place the controller in Autotune mode AutotuningAutotuning Procedure Diagram Time Seconds Manual TuningBand Number is the correct DerivativePossible error codes are Error CodesDisplay Problem Actions Technical Specifications For rated accuracy Platinum 2- and 3-wire, 100 ohms atThermocouple Maximum lead resistance 100 ohmsModel Input Calibration Type Ordering CodesRTD Calibration Values Quick-Helps Press and hold For 3 sec + PV + BUYER’S Remedy is Limited to Either i Repair or Warranty RepairsTwo-Year Limited Warranty Other than those expressly stated herein, There are noUnit Repairs Fuse rating=100 mA Requirements250 Vpk 20 mA Glossary Applications for On/Off Control Quick Setup Instructions Series 16C Temperature Controller Configured Parameters Reference Data Page For Toll-FreeTechnical Assistance in the USA Call Toll Free