Display Menu
Display Parameter | Selection | |
| Decimal Position | |
|
| |
| Filter | |
| Units* | Fahrenheit |
| ||
|
| Celsius |
|
| Kelvin |
*NOTE: Does not appear for linear inputs.
Blanking | , |
(Time selected before setpoint diplay turns off.)
Output Menu
The first parameter that needs to be set in the Output Menu is the Output Type. There are three possible Output Type configurations: PID, On/Off, Alarm, or Off. (If you are not sure which Output Type is best for your particular application, refer to the Glossary for an explanation of Output Types.) The remaining menu parameters in the Output Menu will change, depending on the Output Type selected. The Control Menu will also change, depending on the Output Type selected. If you ordered two outputs, you can select two different Output Types. After setting your Output Type, refer to the correspond- ing sections below for the remaining Output Menu parameters. For simplification purposes, the following sections assume the same Output Type for both outputs. If you selected different Output Types, refer to both of those sections.
Output Type JMPØ1 | Selection |
Display Parameter |
Output 1 Type
Output 2 Type
17