Input Menu
Input Menu (continued) |
|
| Input Jumper Settings |
|
| |
Display Parameter | Selection |
|
|
|
| |
|
|
|
| |||
Input Type | 100 ohm |
|
|
|
| |
| compressed RTD |
|
|
|
| |
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
|
|
|
|
| ||
|
| Input Type | JMPØ1 JMPØ2 | |||
|
| Thermocouple | Out | Out | ||
JMPØ2 |
| |||||
| RTD | Out | Out | |||
| ||||||
|
| Voltage <100 mV | Out | Out | ||
|
|
| Voltage >100 mV | In | Out | |
|
|
| Current Process | In | In | |
|
|
|
|
|
|
|
Note: When you ordered your controller, an input type was specified and the controller was set up accordingly and calibrated for that input type at the factory. If you decide to change input type from
thermocouple to RTD or
JMPØ1
“Calibrate All” option. (Refer to page 56 for information on recalibration.) If you are changing from a temperature input type to a linear input type, you MUST recalibrate and change the jumper settings as indicated in the above table.
Input Menu
Temperature Input Type
Display Parameter | Selection |
Bias (Display offset) | |
Lower Setpoint Limit | Span of Sensor |
Upper Setpoint Limit | Span of Sensor |
Filtering |
Linear Input Type
Display Parameter | Selection |
Bias (Display offset) | |
Low Scale | |
High Scale | |
Lower Setpoint Limit | Span of Sensor |
Upper Setpoint Limit | Span of Sensor |
Filtering |
16