Athena Technologies 16C instruction manual Installation

Page 5

Installation

Measurements between centerlines of panel cut- outs are the minimum recommended.

Unpacking and Inspection

1.Inspect shipping carton for obvious signs of mishandling.

2.After removing the controller from the shipping carton, inspect it carefully for damage. Never attempt to install and use a damaged unit.

3.Verify that the ordering code number indicated on the side of the controller matches what was ordered.

Figure 1.

Recommended Panel Layout for Multiple Controllers

C		C
L	2.850” (72.4 mm)	L
		C
		L
		2.150” (54.6 mm)
		C
		L

1

Image 5

Contents 16C Introduction Precautions FeaturesSafety Warning Contents Installation Mounting DimensionsContact Identification WiringRTDs. Connect 2-wire RTDs Make sure that you are using Appropriate thermocoupleWire, if necessary, to minimize Lead resistance. For long runs Wire RTDs should be usedA 120/240 Vac relay, but normally closed output 2 only Output TypesMode/Enter Key Menu Access KeyLower Key Raise KeySecurity Level, Menu System, and Operating Mode Power OnSecurity Levels Security Levels and Access RestrictionsManual Operating ModesMenu System Overview Been installed. Pressing the Menu Access key indexesMenu System Overview Menu SystemChart of Series 16C Menu System Security Levels On Next See options manual for parameter selections Descriptions Menus and ParameterDisplay Parameter Selection Input MenuJMPØ2 Display Parameter Display MenuOutput Menu Output Menu Control Menu Output Type Recommended Setting secondsParameter Selection On/Off Output TypeDeviation Alarm Setpoint. High process alarmBelow alarm setting Alarm Output Type Autotune Damping Menu Recipe Ramp/ Soak Menu Eter should be set to which will disable itPower Fail Resume Supervisor Menu Options Menu Calibration MenuTo place the controller in Autotune mode AutotuningAutotuning Procedure Diagram Band Manual TuningNumber is the correct Derivative Time SecondsDisplay Problem Actions Error CodesPossible error codes are Technical Specifications Thermocouple Platinum 2- and 3-wire, 100 ohms atMaximum lead resistance 100 ohms For rated accuracyModel Input Calibration Type Ordering CodesRTD Calibration Values Quick-Helps Press and hold For 3 sec + PV + Two-Year Limited Warranty Warranty RepairsOther than those expressly stated herein, There are no BUYER’S Remedy is Limited to Either i Repair orUnit Repairs 250 Vpk 20 mA RequirementsFuse rating=100 mA Glossary Applications for On/Off Control Quick Setup Instructions Series 16C Temperature Controller Configured Parameters Reference Data Page For Toll-FreeTechnical Assistance in the USA Call Toll Free