Powermate P-FTT-160MD Warranty Save all instructions, Emisson Control System Warranty

Page 21

Warranty (Continued)

• Save all instructions

B Emisson Control System Warranty

This MAT Engine Technologies, LLC (METL) outdoor power equipment engine complies with the emissions regulations of:

Powermate® Model No.

Regulatory Agency

 

 

P-FTT-160MD-[E]

United States Environmental Protection Agency (“U.S. EPA”)

P-FTT-160MD

United States Environmental Protection Agency (“U.S. EPA”) and State of California

To the extent there is any conflict between this Emissions Control System Warranty and the equipment manufacturer’s warranty, this Emissions Control System Warranty shall apply except where the equipment manufacturer’s warranty may provide a longer warranty period. Please read your warranty rights and obligations carefully. Some sections of the warranty may not apply to the specific equipment model you purchased. Unless specifically noted otherwise, the terms of the Emission Control System Warranty shall apply to all product engines covered within this manual.

Your Warranty Rightes and Obligations:

The California Air Resources Board, U.S. EPA and MAT Engine Technologies, LLC (METL) are pleased to explain the Emission Control Sys- tem Warranty on your new outdoor power equipment engine.

California (applies only to Model No. P-FTT-160MD)

In California, new spark-ignited small off-road equipment engines must be designed, built and equipped to meet the State’s stringent anti-smog standards.

Other States, U.S. Territories

In other areas of the United States, your engine must be designed, built and equipped to meet the U.S. EPA emission standards for spark- ignited engines at or below 19 kilowatts.

All of the United States

MAT Engine Technologies, LLC (METL) must warrant the emissions control system on your power equipment engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your power equipment engine. Where a warrantable condition exists, METL will repair your power equipment engine at no cost to you including diagnosis, parts and labor.

Manufacturer’s Warranty Coverage:

The emissions control system is warranted for two years. If any emissions-related part on your engine is defective, the part will be repaired or replaced by METL.

Owner’s Warranty Responsibility

As the power equipment engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. METL recommends that you retain all receipts covering maintenance on your power equipment engine, but METL can not deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the power equipment engine owner, you should however be aware that METL may deny your warranty coverage if your power equip- ment engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your power equipment engine to a distribution center or service center authorized by METL as soon as the problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact

MAT Engine Technologies, Inc.

6700 Wildlife Way

Long Grove, IL 60047

Tel: 1-800-737-2112

Questions? Call Toll Free at 1-800-737-2112

20

Copyright © 2009 MAT Engine Technologies, LLC

Image 21
Contents Operator’s Manual Front Tine Rotary TillerSafety Alert Symbols Safety DefinitionsSafety Warning Symbols Control and Operating SymbolsPreparation Safety Important Safety InformationOperation Safety Responsibility of OperatorFuel Safety Operation SafetyStorage Safety REPAIR, MAINTENANCE, and Adjustment SafetyChildren Safety Product Specifications Parts & FeaturesRefer to Engine Manual for Detailed Engine Specs Safety Decals How to Remove Tiller from Carton AssemblyInstall the Wheels See Figure Assembly InstructionsAttach Upper Handle See Figure Assembly Save all instructions Engine Oil Engine PreparationStart the Engine OperationTilling Mode Transport ModeDepth Regulator Lever See Figure Clutch Lever AdjustmentsTo increase belt tension Belt Tension Adjustment See FigureTo Decrease Belt Tension Tilling TipsPeriodic Maintenance Schedule Table MaintenanceService Records ServiceClean Tine Axle Shaft Engine MaintenanceChange Belts Check or Fill Engine CrankcaseHow to Prepare for Storage Technical ServiceProblem Possible Causes Solutions Powermate Rotary Tiller Limited Warranty WarrantyEmisson Control System Warranty Warranty Save all instructionsYour Warranty Rightes and Obligations Manufacturer’s Warranty CoverageHow to Obtain Warranty Service Warranty CoverageExclusions Limitations of LiabilitySystems Covered by this Warranty Parts Description WarrantyPage Manual de operación Motocultivadora rotativa con trenSímbolos de alerta sobre seguridad Definiciones de seguridadSímbolos de advertencia sobre seguridad Símbolos de control y operaciónResponsabilidad DEL Operador Información importante sobre seguridadSeguridad Durante LA Preparación Seguridad Durante LA OperaciónInformación importante sobre seguridad Continuación Seguridad Durante LA Operación ContinuaciónSeguridad DEL Combustible Seguridad DE Almacenamiento Seguridad Durante LA REPARACIÓN, Mantenimiento Y AjusteSeguridad DE Niños Piezas y características Especificaciones del productoMarbetes de seguridad Cómo sacar la motocultivadora de la caja MontajeInstalar EL Regulador DE Profundidad Instalar LAS Ruedas véase la figuraMontaje Continuación Conserve todas las instrucciones Gratuitamente ALFigura 5b Cómo Revisar EL Nivel DE Aceite Y Llenar AL Nivel Apropiado Preparación del motorInspección prearranque OperaciónArrancar el motor Parar el motorVelocidad de operación Operación Continuación Conserve todas las instruccionesApagado Modo de transporte y modo de labranzaPalanca DEL Regulador DE Profundidad Palanca DEL Embrague véase la figuraPalanca del embrague AjustesAjuste DE LA Tensión DE LA Correa Para aumentar la tensión de la correaPara Reducir LA Tensión DE LA Correa Mantenimiento Tabla DE Programa DE Mantenimiento PeriódicoPrograma de mantenimiento Cambiar LAS Correas Mantenimiento ContinuaciónRevisar O Llenar EL Cárter DEL Cigüeñal LubricaciónCómo preparar la motocultivadora para almacenamiento Servicio técnicoProblema CAUSA/S POSIBLE/S Solución / Soluciones Diagnóstico y resolución de problemasGarantía Garantía del sistema pro control de emisiones contaminantes Garantía Continuación Conserve todas las instruccionesDerechos y obligaciones al amparo de la garantía Cobertura de la garantía del fabricanteCómo obtener servicio de garantía Cobertura de la garantíaExclusiones Limitaciones de responsabilidadGarantía Continuación

P-FTT-160MD, P-FTT-160MD-[E] specifications

The Powermate P-FTT-160MD-[E],P-FTT-160MD is a high-performing, versatile inverter generator designed for both recreational and professional use. With a robust engineering focus, this generator provides optimal performance and reliability for a variety of applications, from powering tools on job sites to providing electricity during outdoor camping trips.

One of the standout features of the Powermate P-FTT-160MD is its impressive power output. It boasts a starting wattage of 1600 watts and a running wattage of 1400 watts, making it capable of handling multiple devices simultaneously. This power capacity makes it an excellent choice for running essential appliances, including refrigerators, lights, and power tools, ensuring that users can meet their energy needs with ease.

The generator utilizes advanced inverter technology, which creates clean and stable electricity that is safe for sensitive electronics. This is particularly important for those who need to power devices such as laptops, smartphones, and other gadgets, as the inverter technology minimizes the risk of damage caused by voltage fluctuations. The quiet operation is another advantage, with operating noise levels significantly lower than traditional generators, making it suitable for use in residential areas and quiet outdoor settings.

Portability is a key characteristic of the Powermate P-FTT-160MD. Weighing in at a manageable point, it features a convenient carry handle that makes transportation easy. This design element allows users to effortlessly take the generator to various locations, whether it be for camping trips, tailgating, or emergency power needs at home.

Efficiency is paramount, and the Powermate P-FTT-160MD is equipped with an eco-mode feature. This function adjusts the engine speed based on the load, optimizing fuel consumption and allowing for longer run times on a single tank of fuel. It also contributes to lower emissions, making it an environmentally friendly choice for those who prioritize sustainability.

Safety features are also integrated into the generator design, including overload protection and low oil shutdown, which prevent potential damage and enhance user safety.

In summary, the Powermate P-FTT-160MD-[E],P-FTT-160MD inverter generator excels in delivering reliable power, portability, and user-friendly features. Its combination of advanced technology, efficiency, and safety makes it a trusted option for users seeking dependable power solutions in a variety of environments.