Generac 04077-01, 04109-1, 04079-1, 00789-1, 00844-1 manual Installation

Page 10

Section 1 — Installation

Guardian Air-cooled Generators

Figure 1.4 – Generator and Transfer Switch Mounting Dimensions (6 kW, 8 kW and 10 kW Non-SA)

8 Generac® Power Systems, Inc.

Image 10

Contents Installation, Start-up and Adjustment Manual Introduction Operation and MaintenanceHOW to Obtain Service Authorized Dealer LocationTroubleshooting InstallationPost-installationStart-up Adjustments Introduction Inside Front CoverGeneral Hazards Electrical Hazards Introduction to Installation UnpackingEngine OIL Recommendations Before InstallationLifting the Generator Gaseous Fuel SystemFuel Consumption Reconfiguring the Fuel SystemFuel Pipe Sizing Location and Mounting Transfer SwitchGenerator Installation Installation Generator Mounting Dimensions Sound Attenuated Emergency Circuit Isolation Method Total Circuit Isolation Method11.1 6 KW, 8 KW and 10 KW Units NON-SA Wiring InterconnectionsSound Attenuated Units Installation Generators and GTS Transfer Switches Adapting THREE-PHASE Transfer Switch Grounding the GeneratorBattery Battery Installation Post Installation InspectionFuse Auto Position Using the AUTO/OFF/MANUALAutomatic Transfer Operation OFF PositionSequence Automatic Operation Manual Transfer OperationHigh Temperature Switch Transfer Back to Utility Power SourceLOW OIL Pressure Switch Protection SystemsOverspeed Approximate Crank Cycle Times1 6 KW, 8 KW and 10 KW Units NON-SA Electrical Checks Check Transfer Switch OperationBefore Initial START-UP Generator Tests Under LoadAdjusting the Load Block Checking Automatic Operation1 6 KW Units NON-SA Engine Governor Adjustment2 8 KW and 10 KW Units NON-SA Voltage Regulator Adjustment Overspeed AdjustmentSetting the Exercise Timer 10.1 6 KW, 8 KW and 10 KW Units NON-SATroubleshooting Guide Problem Cause CorrectionInstallation Checklist Guardian Air-cooled Generators Generac Power SYSTEMS, INC