Generac 04077-01, 04109-1, 04079-1, 00789-1, 00844-1 manual Generac Power SYSTEMS, INC

Page 32

GENERAC® POWER SYSTEMS, INC.

P.O. BOX 8

WAUKESHA, WI 53187

Part No. C4219

Revision * (12/13/99)

Printed in U.S.A.

Image 32

Contents Installation, Start-up and Adjustment Manual Operation and Maintenance HOW to Obtain ServiceIntroduction Authorized Dealer LocationInstallation Post-installationStart-up AdjustmentsTroubleshooting Introduction Inside Front CoverGeneral Hazards Electrical Hazards Introduction to Installation UnpackingBefore Installation Lifting the GeneratorEngine OIL Recommendations Gaseous Fuel SystemFuel Pipe Sizing Reconfiguring the Fuel SystemFuel Consumption Generator Transfer SwitchLocation and Mounting Installation Installation Generator Mounting Dimensions Sound Attenuated Emergency Circuit Isolation Method Total Circuit Isolation MethodSound Attenuated Units Wiring Interconnections11.1 6 KW, 8 KW and 10 KW Units NON-SA Installation Generators and GTS Transfer Switches Adapting THREE-PHASE Transfer Switch Grounding the GeneratorBattery Fuse Post Installation InspectionBattery Installation Using the AUTO/OFF/MANUAL Automatic Transfer OperationAuto Position OFF PositionSequence Automatic Operation Manual Transfer OperationTransfer Back to Utility Power Source LOW OIL Pressure SwitchHigh Temperature Switch Protection Systems1 6 KW, 8 KW and 10 KW Units NON-SA Approximate Crank Cycle TimesOverspeed Check Transfer Switch Operation Before Initial START-UPElectrical Checks Generator Tests Under LoadAdjusting the Load Block Checking Automatic Operation2 8 KW and 10 KW Units NON-SA Engine Governor Adjustment1 6 KW Units NON-SA Voltage Regulator Adjustment Overspeed AdjustmentSetting the Exercise Timer 10.1 6 KW, 8 KW and 10 KW Units NON-SATroubleshooting Guide Problem Cause CorrectionInstallation Checklist Guardian Air-cooled Generators Generac Power SYSTEMS, INC