Briggs & Stratton 30235 Add Engine Oil, Add Fuel, When adding fuel, High Altitude

Page 7

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

6.Repeat steps 4 and 5 to secure second wheel.

7.Tip generator so that engine side is down.

8.Line up holes in support leg (E) with holes in generator frame.

9.Attach support leg using 2 capscrews (M8 x 16

mm)(F) and 2 hex nuts (G). Tighten with a

13 mm socket wrench and 13 mm wrench.

10.Return generator to normal operating position (resting on wheels and support leg).

Add Engine Oil

1.Place generator on a flat, level surface.

2.Clean area around oil fill and remove yellow oil fill cap.

NOTE: See the section Oil to review oil recommendations. Verify provided oil bottle is correct viscosity for current ambient temperature.

3.Using oil funnel (optional), slowly pour contents of provided oil bottle into oil fill opening.

NOTICE

Improper treatment of generator can damage it and shorten its life.

•DO NOT attempt to crank or start the engine before it has been properly serviced with the recommended oil. This may result in an engine failure.

4. Replace oil fill cap and fully tighten.

To protect the fuel system from gum formation, mix in a fuel stabilizer when adding fuel. See Storage. All fuel is not the same. If you experience starting or performance problems after using fuel, switch to a different fuel provider or change brands. This engine is certified to operate on gasoline. The emission control system for this engine is EM (Engine Modifications).

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

When adding fuel:

•Turn generator OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.

•Fill or drain fuel tank outdoors.

•DO NOT overfill tank. Allow space for fuel expansion.

•If fuel spills, wait until it evaporates before starting engine.

•Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

•DO NOT light a cigarette or smoke.

1.Clean area around fuel fill cap, remove cap.

2.Slowly add unleaded gasoline (A) to fuel tank (B). Be careful not to overfill. Allow at least 1.5" (4 cm) of tank space (C) for fuel expansion, as shown in Figure 2.

B

Add Fuel

Fuel must meet these requirements:

• Clean, fresh, unleaded gasoline.

• A minimum of 87 octane/87 AKI (91 RON). High

altitude use, see below.

• Gasoline with up to 10% ethanol (gasohol) or up

to 15% MTBE (methyl tertiary butyl ether) is

acceptable.

C

Figure 2 — Fuel Expansion

A - Fuel

B - Fuel Tank

C - Tank Space

A

NOTICE

Avoid generator damage.

Failure to follow Operator’s Manual for fuel reccomendations voids warranty.

•DO NOT use unapproved gasoline such as E85.

•DO NOT mix oil in fuel.

•DO NOT modify engine to run on alternate fuels.

3.Install fuel cap and let any spilled fuel evaporate before starting engine.

High Altitude

At higher altitudes (over 5,000 feet), 85 octane/85 AKI (89 RON) gasoline is recommended. High-altitude use may require a carburetor jet kit to improve performance and decrease fuel consumption. See an Authorized Briggs & Stratton Dealer for more information.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Watts Revision Serial Number Engine Model Number Date Purchased Where to Find UsTable of Contents Hazard Symbols and Meanings Safety RulesWhen transporting or repairing equipment When adding or draining fuelWhen starting equipment When operating equipmentEquipment Description AssemblyShipment Contents Install Wheel KitFuel must meet these requirements When adding fuelAdd Engine Oil Add FuelSpecial Requirements Connecting to a Building’s Electrical SystemSystem Ground Generator LocationFeatures and Controls 120/240 Volt AC, 30 Amp, Locking Receptacle ReceptaclesNema L14-30 Generator Adapter Cord SetStarting the Engine OperationStopping the Engine Connecting Electrical LoadsExample Power ManagementDon’t Overload Generator CapacityEmissions Control MaintenanceMaintenance Schedule General RecommendationsOil Recommendations Generator MaintenanceCleaning OilAdding Engine Oil Checking Oil LevelChanging Engine Oil Service Spark Plug Service Air CleanerClean Spark Arrester Screen Check Valve Clearance Carburetor AdjustmentClean and inspect the spark arrester as follows Engine Air Cooling SystemStorage Troubleshooting Engine Technical Information SpecificationsReplacement Parts Maintenance ItemsWarranted Parts Owner’s Warranty ResponsibilitiesLength of Coverage No Charge Maintenance Consequential CoverageClaims and Coverage Exclusions Warranty Period This page reserved Dónde encontrarnos Controles y características Resolución de problemas Especificaciones GarantíasReglas de seguridad MontajeSímbolos de peligro y sus significados Normas de seguridadCuando transporte o repare el equipo Cuando anada combustible o vacíe el depósitoCuando ponga en funcionamiento el equipo Cuando opere el equipoContenido de la caja MontajeDescripción del equipo Desembalaje del generadorGran altitud Agregar aceite al motorAgregue combustible Cuando anada combustibleRequisitos Especiales Tierra del sistemaConexión al sistema eléctrico de un edificio Ubicación del generadorControles y características del generador Juego de cables del adaptador del generador Tomas eléctricasTomas eléctricas dobles de 120 V CA y 20 a Dispositivo de seguridad de 120/240 V, 30 aEncienda el motor OperandoParada del motor Conexión de cargas eléctricasControl de la energía No sobrecargar el generadorCapacidad EjemploControl de emisiones MantenimientoPlan de mantenimiento Recomendaciones GeneralesRecomendaciones sobre el aceite Mantenimiento del GeneradorLimpieza AceiteAdición de Aceite del Motor Comprobación del Nivel de AceiteCambio de Aceite del Motor Servicio del bujía Servicio del depurador de aireLimpie la Pantalla Apagachispas Limpie e inspeccione el apagachispas de la siguiente manera Sistema de refrigeración de aireComprobación de holgura de la válvula Ajuste del CarburadorAlmacenamiento Problemo Causa Accion Resolución de problemasEspecificaciones del Motor Información Técnica Sobre el MotorPotencia Nominal Especificaciones del GeneradorPiezas garantizadas Responsabilidades de la garantía del propietarioDuración de la cobertura Cobertura de daños derivados Servicio gratuitoSolicitudes y exclusiones de cobertura MantenimientoPeríodo DE Garantía

30235 specifications

The Briggs & Stratton 30235 is a powerful and efficient portable generator designed to provide reliable backup power. Ideal for homeowners and recreational users alike, this model boasts a range of features and technologies that enhance its performance and usability.

One of the standout features of the Briggs & Stratton 30235 is its 306cc engine, which delivers 7,000 starting watts and 5,500 running watts. This robust power output ensures that essential appliances, tools, and devices can be effectively supported during power outages or when on outdoor adventures. The generator is equipped with a durable 4-gallon metal fuel tank, providing up to 13 hours of run time at 50% load, which means users can count on extended operation without frequent refueling.

The generator employs a reliable and user-friendly design, featuring an easy-to-read LED display that provides important information such as power output and operational status. Additionally, it includes an automatic low oil shutdown feature, which protects the engine from damage by shutting down the unit when oil levels are too low. This functionality not only prolongs the life of the generator but also assists users in maintaining optimal performance.

For enhanced portability, the Briggs & Stratton 30235 comes with a built-in handle and never-flat wheels, making it easy to transport and position wherever needed. Its compact footprint allows it to be stored without taking up excessive space, making it an ideal choice for those with limited storage options.

The generator also features multiple outlets, including 120V 20A NEMA 5-20R duplex receptacles and a 120/240V 30A L14-30R lockable receptacle. This versatility allows users to connect a variety of devices and appliances, enhancing its usability for different applications, from home backup to camping trips.

In terms of safety, the Briggs & Stratton 30235 includes circuit protection to prevent overloading, ensuring that connected devices are protected. Moreover, it runs quietly compared to many other generators in its class, making it suitable for use in residential areas without causing a disturbance.

Overall, the Briggs & Stratton 30235 combines power, portability, and practicality, making it a top choice for those in need of reliable backup power or portable energy solutions. With its thoughtful design and advanced features, this generator stands out as a dependable companion for any situation that requires consistent electrical support.
Top Page Image Contents