Frozen Recoil Starter
If the starter is frozen and wilt not turn the engine, proceed as follows:
1.Pull as much rope out of the starter as possible.
2.Release the starter handle and let it snap back against the starter.
3.If the engine still fails to start, repeat the first two steps. If continued attempts do not free starter, follow the electric starter procedures to start.
4.Avoid freezing of the recoil starter by following instructions below.
2.Squeeze the auger control grip and the augers will turn. Release it and the augers wilt stop.
3.Squeeze traction control grip and the snow thrower will move. Release it and drive motion will stop.
4.NEVER move shift lever without releasing drive clutch.
To Engage Augers
To engage the augers and start throwing snow, squeeze the auger control grip against the left handle. Release to stop the augers.
Before Stopping
1.Run engine for a few minutes to help dry off any moisture on engine.
2.Avoid freezing of the starter by following these steps before stopping the snow thrower:
Recoil Starter
a.With the engine running, pull the starter rope with a rapid, continuous full arm stroke three or four times.
Electric Starter
a.Connect power cord to switch box, then to 120 Volt AC receptacle.
b.While engine is running, push starter button and spin the starter for several seconds.
c.Disconnect power cord from the receptacle first, then from the snow thrower.
NOTE: The unusual sound from pulling the starter rope in the case of the recoil starter, or from spinning the starter in the case of the electric starter, will not harm the engine.
To Stop Engine
1.Move throttle control to "stop" or "off'position.
2.Remove the ignition key. Do not turn key.
3.Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended.
NOTE: Do not lose ignition key. Keep it in a safe place. Engine will not start without the ignition key.
4.Wipe all snow and moisture from the carburetor cover in the area of the control levers. Also, move control levers back and forth several times.
To Engage Drive
1.With the engine running near top speed, move shift lever into one of the five FORWARD positions or two REVERSE positions. Select a speed appropriate for the snow conditions that exist. Use the slower speeds until you are familiar with the operation of the snow thrower.
Operating Tips
Allow the engine to warm up for a few minutes as the engine will not develop full power until it reaches operating temperature.
_ WARNING: Muffler, engine and surrounding
areas become hot and can cause a burn. Do not touch.
For most efficient snow removal, remove snow immediately after it falls.
Discharge snow downwind whenever possible. Slightly overlap each previous swath.
Set the skid shoes 1/4" below the scraper bar for normal usage. The skid shoes may be adjusted upward for
Be certain to follow the precautions listed under "To Stop Engine" to prevent possible
Clean the snow thrower thoroughly after each use.
Tire Chains (ifequipped)
Tire chains, if equipped, should be used whenever extra traction is needed.
Chute Clean-Out Tool
The chute
1.Release both the auger control lever and the traction/auger control locklever.
2.Stop the engine by removing the ignition key.
3.Remove the
4.Use the
5.
6.While standing in the operator's position (behind the snow thrower), engage the auger clutch lever for a few seconds to clear any remaining snow or ice from the discharge chute before continuing to clear snow.
10