1.Locate the shave plate in Figure 6. The space between this shave plate and ground can be adjusted.
2.For close snow removal on smooth surface, raise skid shoes higher. See Figure 5.
3.Place skid shoes in middle or lower position when the area to be cleared is uneven. See Figure 5.
4.Adjust skid shoes by loosening the four hex nuts and carriage bolts as shown in Figure 5. Move skid shoes to desired position.
5.Make certain the entire bottom surface of skid shoe is against the ground to avoid uneven wear on the skid shoes. Retighten nuts and bolts securely.
Tire Pressure
The tires are overinflated for shipping purposes.
1.Check tire pressure. Maintain pressure between 15 to 20 psi. Refer to tire sidewalls for recommended tire pressure.
NOTE: If the tire pressure is not equal in beth tires, the unit may pull to ene side or the ether.
|
| pressure |
_ | WARNING: Maximum tire | under |
| any circumstance is 20 psi. Equal tire pressure | |
should be maintained at all times. Excessive pressure (over 20 psi) when seating beads may cause tire!rim assembly to burst with force sufficient to cause serious injury.