Eiki EIP-1000T owner manual This Apparatus Must be Earthed

Page 2

IMPORTANT

For your assistance in reporting the loss or theft of your Projector, please record the Serial Number located on the bottom of the projector and retain this information.

Before recycling the packaging, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 10.

Model No.: EIP-1000T

Serial No.:

SPECIAL NOTE FOR USERS IN THE U.K.

The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporat- ing a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used.

Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type.

DANGER:

The fuse from the cut-off plug should be removed and the cut-off plug destroyed immedi- ately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet, as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

WARNING:

THIS APPARATUS MUST BE EARTHED.

IMPORTANT:

The wires in this mains lead are coloured in accordance with the following code: Green-and-yellow : Earth

Blue

: Neutral

Brown

: Live

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows:

The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety earth symbol or coloured green or green-and-yellow.

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

Image 2
Contents EIP-1000T This Apparatus Must be Earthed If YOU have ANY DOUBT, Consult a Qualified ElectricianPage Introduction A. onlyEsperanza Rancho Santa Margarita, CA 92688-2132 TEL Eiki PROJECTOR, Model EIP-1000TEiki INTERNATIONAL, INC Using the Menu Screen For Future ReferenceContents Maintenance Maintenance Indicators Regarding the Lamp ReferencePower Sources CleaningAccessories Power-Cord ProtectionSafety Check Damage Requiring ServiceReplacement Parts OverloadingDo not block the exhaust and intake vents Rest your eyes occasionallyAvoid locations with extremes of tem- perature Other connected equipment Using the projector in other countriesTemperature monitor function QCNWGA075WJPZ AccessoriesOptional accessory QACCDA007WJPZLever 28, 48 Lamp indicator Focus ring For adjusting the focusHeight 31 Adjust Part Names and FunctionPart Names and Functions Rear adjustment FootExhaust vent Speaker Kensington Security Standard connector Rear ViewPicture Mode BAR, Cinema ZoomInserting the Batteries Attach the cover and slide it until it clicks into placeUsable Range STANDBY-ON Setup and ProjectionQuick Start On the remote control Upper sideStandard Setup Front Projection Setting up the ProjectorSetting up the Projector Ceiling-mount SetupProjection PRJ Mode Example Stretch Mode Picture SizeWhen using a wide screen 169 and projecting 169 image Screen Size and Projection DistanceWhen using a normal screen 43 and projecting 169 image Samples of Cables for Connection Sub adaptor Connecting to Video EquipmentTo audio output Connecting to Video Equipment To INPUT1 terminal To Audio Terminal RGB Cable Connecting to a ComputerTo audio output terminal To RGB output terminal Computer Connecting to a Monitor with RGB Input Terminal Connecting to an Amplifier or Other Audio Equipment Turning the Projector On/Off Connecting the Power CordLamp indicator Power indicator STANDBY-ON button On button Turning the Projector onJector or eSTANDBY on the re Projector into standby modePress oSTANDBY-ON on the pro Mote control, then press that butAdjusting the Screen Size Switching the Input ModeAdjusting the Projected Image Adjusting the Focus Image ProjectionAdjust lever Make small adjustments Rear adjustment foot Adjusting the HeightUse the rear adjustment foot to make the projector level HeightScreen and turn off the sound Adjusting the VolumeAV Mute button Volume buttons Correcting Trapezoidal Distortion Press g Keystone to enter Keystone Correction modePress P/Q or O/R to adjust Keystone Correction Press g KeystoneResize Mode Press HresizeComputer Auto Sync Auto Sync Adjustment Operating with the Remote ControlSelecting the Picture Mode Freezing a Moving ImageComponent/INPUT 3/INPUT Menu ItemsInput 1 Component/INPUT Input 1 RGB/INPUT2 RGBItems you can set with Help menu Help menu nPress Q or O and select Picture to adjust Using the Menu ScreenMenu Selections Adjustments Press BmenuPress O or Q to adjust the item selected To adjust the projected image while watching itPress P or R and select Bright to adjust Press hENTERPicture Adjustment Picture menu Example Picture screen menu for Input 3 mode2Adjusting the Image Menu operation nAdjusting the Projected Image SCR ADJ menu ImageAdjusting the Projector Function PRJ ADJ menu 3Auto Power Off Function This function changes the fan rotation speedPress Oor Qto select Help, then Troubleshooting with Help menuUtilizing Help menu functions Maintenance Cleaning the projectorMaintenance Indicators Temperature warning indicator Lamp indicator Power indicatorRed on Internal Blocked air intake Relocate the projector to Replacing the Lamp Regarding the LampLamp Remove the lamp unit cover Removing and Installing the Lamp UnitDisconnect the power cord Resetting the Lamp Timer Connecting Pin Assignments GNDComputer Compatibility Chart SVGA, XGA, SXGA, SXGA+Troubleshooting 23-27An input signal type Picture is pink no green Specifications Product type Projector Model EIP-1000T Video systemDimensions Stretch IndexSide BAR Index Deutschland & Österreich CanadaEastern Europe Japan & Worldwide