Eiki EIP-1000T owner manual An input signal type Picture is pink no green

Troubleshooting (Continued)

Problem		Check	Page
Picture is green on	•	Change the input signal type setting.
INPUT 1 (Component)/		Select “Color is faded or poor” in the “Help” menu, and then select
INPUT 2 (Component).		an input signal type.	46
Picture is pink (no green)
on INPUT 1 (RGB)/INPUT
2 (RGB).
Picture flickers on INPUT	•	Select “Initiate “Auto Sync” Adjustments” after selecting “Vertical
1 (RGB)/INPUT 2 (RGB).		stripes or flickering image appear” in the “Help” menu, and then
		press ENTER.	46
		If the picture hasn't improved, select “Adjust horizontal noise”, and
		then press ENTER. After that, press O or Q to adjust.
Picture is too bright and	•	Image adjustments are incorrectly set.	42
whitish.
The cooling fan becomes	•	When temperature inside the projector increases, the cooling fan	–
noisy.		runs faster.
The lamp does not light	•	The lamp indicator is illuminating in red.
up even after the		Replace the lamp.	48, 51
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes	•	Cables incorrectly connected to the projector or the connected	23–27
flickers.		equipment works improperly.	46
	•	Select “Vertical stripes or flickering image appear” in the “Help”
		menu and make the necessary adjustments.	51
	•	If this happens frequently, replace the lamp.
The lamp needs much	•	The lamp will eventually need to be changed.	51
time to turn on.		While the remaining lamp life draws to a close, replace the lamp.
Picture is dark.

This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.

56