Cooper Lighting Radio manual WR 3M

Page 20

Page 20 of 21

WR 3M

THE PERIOD OF ALL IMPLIED WARRANTIES APPLICABLE TO

THIS PRODUCT INCLUDING ANY IMPLIED WARRANTY OF

MERCHANTABILITY OR FITNESS, OR FITNESS FOR A

PARTICULAR PURPOSE IS LIMITED TO 12 MONTHS FROM THE

DATE OF PURCHASE BY THE USER.

Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary, from state to state.

www.Cooperhandtools.com

Weller is a registered Trademark and registered Design of Cooper

Industries, Inc.

U.S Mailing Address:

Cooper Hand Tools

P.O. Box 728

Apex, NC 27502-0728

U.S Shipping Address:

1000 Lufkin Road

Image 20
Contents Buttons 1 , 2 Button 1·2·3Air Receptacle 1 , 2Table of Contents InstructionsDescription Safety InformationPacking List WP 80 WR3000M Tools and HoldersDXV 80 WR3000M WR 3M Technical Data USB PortInitial Set-up Connected to the air portOperating Guidelines Selecting a channel, switching on or OFFSetting the Temperature Temperature Setting using the Radio Buttons 1 , 2 or Setting the Air FlowSetting the Pre-set Temperature on Radio Buttons 1 , 2 or Switching the Vacuum Pick-up Pump ON/OFF Special FunctionsSoldering and Desoldering Selecting Menu 1 Special FunctionsSetting the Standby Temperature Possibility of manual temperature reduction Setback whenSetback Time Soldering / desoldering tool is not in useSetting the Automatic Switch-Off Time AUTO-OFF Settings Tool Operation without Switching HolderTool Operation with Switching Holder OFF functionsLimiting the Time HAP on time for Hot-Air Pencil Setting the Window FunctionSwitching the Temperature Display Setting the Vacuum OFF delay VAC OFF Setting the Vacuum on delay VAC onSwitching the Lock Function On/Off Depressing the Radio buttons 1 or 2 while OFF is displayedResetting the Special Functions to Factory Default Settings Setting the Station Identification Remote ID codeSelecting Menu 2 Special Functions Special Functions NavigationChanges Exit Factory Control Check FCCControl Check at 212 F / 100 C Depress Radio Button 3 to exit the menu item without savingChanging the Filter Setting the Pick-Up Vacuum LevelMaintaining and Servicing the WR 3M Fault Indications and Correction Indication/symptom Possible cause Corrective ActionAccessories Warranty DisposalWR 3M XX XXX XX / 03.07 2007 Cooper Industries