Cooper Lighting Radio manual Selecting Menu 2 Special Functions, Special Functions Navigation

Page 14 of 21

WR 3M

2.Enter the 1, 2, or 3-digit LOCK code with the UP or DOWN Scroll Key.

3.Depress Radio Button ┌ 3 ┐. The Station is now unlocked.

Resetting the Special Functions to Factory Default Settings

1.Select the Special Functions Menu 1.

2.Depress and hold down Radio Button ┌ 3 ┐.

3.Then Depress the UP and DOWN Scroll Keys simultaneously.

"FSE", Factory Setting Enabled appears in the display.

The Rework Station is now reset to the factory default settings. 4. Exit the menu with Radio Button ┌ 3 ┐ (EXIT).

7.1Selecting Menu 2 Special Functions

Special Functions	Navigation
LEVEL	↑ ┌ 1 ┐
ID
	↓ ┌ 2 ┐
FCC
	EXIT ┌ 3 ┐
PICK-UP

1.Select the desired channel ┌ 1 ┐, ┌ 2 ┐ or ┌ 3 ┐ for entering the special functions.

2.Depress and hold down the UP and DOWN Scroll Keys simultaneously.

"– 2 –" appears in the display after 4 seconds.

3.Release the Scroll Keys.

Selection of the special functions of Menu 2 is activated. The settings can now be made.

−Select menu items with Radio Buttons ┌ 1 ┐ and ┌ 2 ┐.

−Exit the menu with Radio Button ┌ 3 ┐ (EXIT).

Defining the Maintenance Level of the Vacuum System ( VAC and bar )

−The value is shown in mbar at which the electric vacuum gauge issues a vacuum level warning signal. The LED (3) of the vacuum pump switches from green to red. The set value is dependent on the desoldering tiplets used.

−Factory setting: -600 mbar

Settable: -400 mbar to -800 mbar

1.Select the menu item LEVEL in Menu 2.

2.Set the vacuum value LEVEL with the UP or DOWN Scroll Key.

3.Proceed to the next menu item with the Radio Button ┌ 1 ┐ (back) or ┌ 2 ┐ (forward) or exit the menu with Radio button ┌ 3 ┐ (EXIT).

Setting the Station Identification ( REMOTE ID code )

When the optional USB port is used, several WR 3M Rework Stations can be activated and remote-controlled. Each Station