Cooper Lighting Radio manual Special Functions, Switching the Vacuum Pick-up Pump ON/OFF

Page 9

WR 3M

Page 9 of 21

2.The current air flow in percentage is shown in the display for approximately 2 seconds.

3.Set the desired flow by Depressing the UP or DOWN Scroll Key.

6.4Switching the Vacuum Pick-up Pump ON/OFF

ZDepress the Pick-UpRadio Button.

 

The pump is switched on or off, depending on the initial state. In

 

switched-on mode, the LED (8) next to the Pick-UpRadio Button

Note

lights up green.

The vacuum pump is not designed for continuous operation. (60

 

Seconds On, 30 Seconds Off). To protect itself, the pump

 

switches off automatically after 5 minutes of continuous operation.

2 s ➾

Menu 1

4 s ➾

Menu 2

1x ➾

ON/OFF

6.5Soldering and Desoldering

ZPerform the Soldering / Desoldering work in accordance with the operating instructions of your connected soldering tool.

7 Special Functions

The special functions are divided into 2 menu levels:

−Menu 1 with setting options for Standby temperature, temperature deactivation (Setback), automatic switch-off time (AUTO-OFF), temperature Offset, Window function, Degrees °F / °C conversion, switch-on time (On Time) for hot-air pencil, vacuum OFF delay (VAC OFF), vacuum ON delay (VAC ON) and Lock function.

−Menu 2 with setting options for Station Desoldering vacuum level, ID code, Factory Control Check (FCC), and Pick-Up vacuum level

(%).

Selecting Menu 1 Special Functions

Special functions

STANDBY SETBACK AUTO OFF OFFSET WINDOW °F / °C

ON TIME VAC OFF VAC ON

Navigation

↑┌ 1 ┐

↓┌ 2 ┐

EXIT ┌ 3 ┐

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Button 1·2·3 Buttons 1 , 2Air Receptacle 1 , 2Instructions Table of ContentsSafety Information Packing ListDescription Tools and Holders DXV 80 WR3000MWP 80 WR3000M USB Port WR 3M Technical DataConnected to the air port Initial Set-upSelecting a channel, switching on or OFF Setting the TemperatureOperating Guidelines Setting the Air Flow Setting the Pre-set Temperature on Radio Buttons 1 , 2 orTemperature Setting using the Radio Buttons 1 , 2 or Special Functions Switching the Vacuum Pick-up Pump ON/OFFSoldering and Desoldering Selecting Menu 1 Special FunctionsPossibility of manual temperature reduction Setback when Setting the Standby TemperatureSetback Time Soldering / desoldering tool is not in useSettings Tool Operation without Switching Holder Setting the Automatic Switch-Off Time AUTO-OFFTool Operation with Switching Holder OFF functionsSetting the Window Function Switching the Temperature DisplayLimiting the Time HAP on time for Hot-Air Pencil Setting the Vacuum on delay VAC on Setting the Vacuum OFF delay VAC OFFSwitching the Lock Function On/Off Depressing the Radio buttons 1 or 2 while OFF is displayedSetting the Station Identification Remote ID code Resetting the Special Functions to Factory Default SettingsSelecting Menu 2 Special Functions Special Functions NavigationFactory Control Check FCC Changes ExitControl Check at 212 F / 100 C Depress Radio Button 3 to exit the menu item without savingSetting the Pick-Up Vacuum Level Maintaining and Servicing the WR 3MChanging the Filter Indication/symptom Possible cause Corrective Action Fault Indications and CorrectionAccessories Disposal WarrantyWR 3M XX XXX XX / 03.07 2007 Cooper Industries
Top Page Image Contents