WR 3M | Page 5 of 21 |
The Weller WR 3M Rework Station offers the following additional features / functions:
−Automatic tool detection and activation of the related control parameters
−Operates with all Weller tools listed in the Accessories section on page 18
−Digital Temperature Control
−Temperature Offset
−Programmable Temperature (Setback)
−Standby and Lock functions
−
−Antistatic device design in accordance with EOS / ESD safety standards
−USB port for control, evaluation and documentation via PC
−Additional vacuum port for component handling
4.2WR 3M Technical Data
Dimensions Weight
Power supply voltage Power consumption EOS / ESD Properties
Fuse
Temperature Control range
Temperature accuracy
Temperature stability Hot Air / Vacuum Pump
(duty cycle: 30 seconds on - 30 seconds off )
Vacuum
(duty cycle: 60 seconds on - 30 seconds off )
USB Port
L x W x H (inches): 10.75 x 9.25 x 4.02 Approximately. 14.8 lbs.
120 VAC, 60 Hz
400 Watts
All Tool Handles, Cordsets and Air Flow are Static Free
4 Amp
Variable in (1) degree increments from 150 °F – 999 °F
Controllable temperature range is tool- dependent
±17 °F ( Average tip temperature can be offset ± 9 °F at idle with no load )
±9 °F
Max. vacuum 0.7 bar
Max. delivery rate 18 l/min
Hot air max. 15 l/min
Max. vacuum 0.5 bar
Max. delivery rate 1.7 l/min
The control unit is equipped with a mini USB port (25). Weller software, included on a CD, provides station monitoring and control via the USB port.
With the software you;
−can carry out a software update ("Firmware Updater“) on your control unit.