・ Video Off In Suspend, ・ Suspend Type

P3 Series	User's Manual

・Video off Method

	This selection will cause the system to turn off the vertical and
V/HSYNC+Blank	horizontal synchronization ports and write blanks to the video
	buffer.
Blank Screen	This option only writes blanks to the video buffer.
DPMS Support	Initial display power management signaling.( default)

・Video Off In Suspend

This determines the manner in which the monitor is blanked. The choices are Yes Video will off and No Video always on.

・Suspend Type

This item allows you to select ACPI Suspend Type.

・MODEM Use IRQ

This determines the IRQ in which the MODEM can use. Default option is IRQ3.

・Suspend Mode

If system activity is not detected for the length of time specified in this field, all devices except CPU will be shut off. Select [Disabled] can not suspend.

・HDD Power Down

If HDD activity is not detected for the length of time specified in this field, the HDD will be shut off.

・Soft-Off by PWR-BTTN

Pressing the power button for more than 4 seconds forces the system to enter the Soft- Off state.

・CPU THRM-Throttling

This option allows you to adjust the CPU temperature. If the CPU temperature gets to the temperature you set, CPU frequency will be throttling. The range is 12.5% to 87.5%, increase by 12.5%.

・Wake-Up by PCI card

When set to [Enabled], the feature allows your system to be awakened from the Power saving modes through any event on PCI device.

・Power On by Ring

During Disabled, the system will ignore any incoming call from the modem. During Enabled, the system will boot up if there's an incoming call from modem.

・Resume by Alarm

The field is used to enable or disable the feature of booting up the system on a scheduled time/date.

・Date (of Month) Alarm

[0]: This option power-on the system everyday according to the time set in the “Time (hh:mm:ss) Alarm” item.

[1-31]:This option selects a date you would like the system to power-on. The system will power-on on the date set, and the time set in the “Time (hh:mm:ss) Alarm” item.

・Time (hh:mm:ss) Alarm

This item sets the time you would like the system to power-on.

・Primary/ Secondary IDE 0/1

When the Primary/Secondary IDE 0/1 devices are activity, whether cancel PC and IDE saving mode.

・FDD, COM, LPT Port

When the FDD, COM, LPT Port are activity, whether cancel the PC and IDE saving mode.

・PCI PIRQ[A-D]#

This option is for setting PCI PIRQ.

- 33 -