Sanyo PLC-HP7000L owner manual Shutter, Protection, Release key, Management

Page 67

Setting

Shutter

Shutter function is available to block out light to the screen, so that the screen can be used for the other presenters.

Protection

Prohibit the shutter operation from the remote control and the projector's side control.

……………Permit the shutter operation from

both the remote control and the projector's side control.

……………Prohibit the shutter operation from

the remote control.

……………Prohibit the shutter operation from

the side control.

……………Prohibit the shutter operation from

both the remote control and the projector's side control.

Release key

By using the Release function from the following options, the Shutter can be released when it stays activated (i.e. when it is closed. )

Any ……By pressing any button on the projector's side

control or the remote control, the shutter can be released when it is closed, and meanwhile the function of the selected item will come into effect.

SHUTTER…Only by pressing the SHUTTER button on the projector’s side control or the remote control the shutter can be released when it is closed.

In addition, when the Shutter is functioning, only the following buttons are active:

--INPUT button and ON/STAND-BY button on the projector’s side control

--INPUT 1/2/3 buttons and STAND-BY button on the remote control

Management

The Shutter Management function turns off the projection lamp when the projector is left with the shutter closed and the set time has passed away. The count-down time can be set between 5 and 480 minutes. When the count-down time has elapsed, the shutter will be opened

up automatically and the lamp will be turned off to cool itself down. The LAMP/SHUTTER indicator is blinking blue during this cooling-off period. When the lamp has been fully cooled down, the POWER indicator turns

green lighting and the LAMP/SHUTTER indicator keeps

blinking. Should the ON / STAND-BY button be pressed in this condition, the projection lamp will be turned on and the LAMP/SHUTTER indicator turns off.

Note:

The Shutter Management function cannot be halted.

Shutter

Note:

When the shutter is closed, if the projector is turned off and on, the shutter will be released.

67

Image 67

Contents Network Set-up and Operation  Projection lens is optionalFeatures and Design Table of Contents Please, help us to conserve the environ- ment we live Safety PrecautionTo The Owner For EU UsersMounting kit approved by the manufacturers Safety InstructionsAir flow Air Intake Vent Safety Instructions Air CirculationTop Panel Cautious use of equipment with laser technology Positioning PrecautionsNever allow children to touch the lens Safety Instructions Moving the ProjectorCompliance AC Power Cord RequirementAC Power Cord for the United States and Canada AC Power Cord for the United KingdomFront ① Part Names and FunctionsPart Names and Functions Rear Terminal Side Control Indicators on the top panel Part Names and Functions Side Control and IndicatorsPart Names and Functions Remote Control Part Names and Functions Wired Remote Control Transmitter Remote Control Receivers and Operating Range16.4’ 5 m Adjustable Feet Part Names and Functions Remote Control CodeON/OFF Lens Installation InstallationRemoving the lens Attaching the lens to the projector InstallationLNS-W34 Focus adjustmentBe Sure to Check for Safety Focus correctionDigital MonitorOutput SerialMonitor Out Signal Table Projector side AC Outlet side Installation Connecting the AC Power CordFor Continental Europe Turning On the Projector Basic OperationEnter a PIN code Turning Off the Projector What is PIN code?Power off? disappears after 4 seconds Basic OperationOn-Screen Menu Basic Operation How to Operate the On-Screen MenuRemote Control Side ControlBasic Operation Main Menu Lens Operation Zoom AdjustmentLens Shift Adjustment Basic Operation Operating with Projector ControlInformation Menu Basic Operation Operating with Remote ControlMouse Pointer button Timer buttonUser 1 of PIP example User 2 of PIP examplePoint Basic Operation Keystone CorrectionStandard Corner correctionArrow Finger Wireless Mouse OperationBasic Operation Pointer Function Mouse Pointer buttonSide Control Side Control/Remote Control OperationRemote Control Operation Direct OperationRgbpc analog When Selecting Input 2 5 BNC Input JacksInput Selection Computer Input Source Selection Menu OperationRgbav Hdcp When Selecting Input 1 Computer Input TerminalsWhen Selecting Input 3 AV Terminals Input Selection Video Input Source SelectionSelecting Computer System Manually Computer InputComputer System Selection Automatic Multi-Scan SystemDirect Operation Computer Input Auto PC AdjustmentTo store the adjusted parameters PC adjust MenuPosition H Computer Input Manual PC AdjustmentAdjust and then press the Point or the Select Current modeComputer Input Mode freeStore Image select Menu Computer Input Image Level SelectionColor M Computer Input Image AdjustmentImage adjust Menu ListALL DEL MenuColor Palette DELAdvanced color Offset Red/Green/BlueAuto picture control Off Auto picture control OFF positionComputer Input Screen Size Adjustment Digital zoom + Reset............... Reset all the adjusted values. PressCustom adj Custom adjKeystone Ceiling Rear Pb/Cb, Pr/Cr Jacks Video InputVideo System Selection Video Jack or S-video JackNatural Natural picture level preset on the projectorPicture level adjusted with fine tone Video Input Image Level SelectionTint Video Input Image AdjustmentUse the Point buttons to adjust the setting value ColorVideo Input Use the Point buttons to select the advanced color ModeProgressive Noise reduction mode is OnNoise reduction Off……………When set to On, the aspect ratio is Video Input Screen Size AdjustmentNatural Wide Keystone Ceiling Setting SettingSetting Menu Language Position Logo select Capture Capture Logo PIN code lockLogo PIN code lock Enter a Logo PIN code Change the Logo PIN code lock settingChange the Logo PIN code lock setting Enter a Logo PIN codePosition Menu Picture in PictureEdge blending To store the adjusted dataFrame lock Set the Frame Lock to Main picture or Sub pictureAdvanced Color matching...... Select Advanced color matching Color matchingAdvanced color matching Cancels the Advanced colorHdmi setup Measured information Advanced color matching Test patternFan control Filter controlLamp control Filter controlSimple mode buttons To change the code for the remote controlTo change the code for the projector Timer left before Lamp is off Power managementShut down ...... When the lamp has been fully cooled Timer............... If the input signal is interrupted18000 TimerStop or Cancel the P-timer via Remote Control Pointer…Unlocked Key lockPIN code lock Security Key lock and PIN code lockPIN code change Change the PIN code lock settingEnter a PIN code Release key ShutterShutter ProtectionClosed caption Video delay controlClosed caption Accumulated time of the lamp Usage Be sure to reset the Lamp replacement counter afterLamp counter Lamp counter . . . . . . . . . This item shows the totalTest pattern Factory defaultFilter counter Filter counterPlease wait.... . message Maintenance and CareReset the Filter counter p.73 and the Scroll counter p.73 Filter InstructionsModel No.. of your projector PLC-HP7000L Maintenance and Care Replacing the Filter CartridgeOrder Replacement Filter Cartridge RecommendationScroll counter Scroll counter Reset? appears Maintenance and Care Resetting the Filter CounterResetting the Scroll Counter Filter counter Filter counter Reset? appearsFollow these steps to replace the lamp Maintenance and Care Lamp ReplacementLamp replacement icon Lamp Replace indicatorPLC-HP7000L Maintenance and CareLamp Handling Precautions Order Replacement LampCleaning the Projector Cabinet Maintenance and Care Cleaning the Projection LensUnplug the AC power cord before cleaning Then check the matters below Is the filter clean? Replace the filter with a new oneProblem Solutions TroubleshootingAppendix Appendix Does not work Wireless mouseIndicators blink or You cannot operateComputer Input/HDMI Input/Video Input Appendix Menu TreeComputer Input Video Input Hdmi Input/Video InputScreen Top/Bottom Start Left/Right Width Top/Bottom Width Languages provided Position Menu Normal/DoubleOff/On Logo PIN code lock Picture in Picture Left/Right Start Edge blending480 Min Direct on Pointer Timer Security Shutter Closed captionTimer Yes/No Filter Release keyProjector is operating normally Appendix Indicators and Projector ConditionLamp Replace Projector is detecting abnormal conditionProjector Condition Indicators72.004 Appendix Compatible Computer SpecificationsResolution Mechanical Information Appendix Technical SpecificationsPJ Link Notice Lens ReplacementTo the sales and service Appendix Optional PartsDigital DVI-D DVI 24 PIN Appendix Configurations of TerminalsLAN Terminal Appendix PIN Code Number Memo Appendix Dimensions Note Appendix List of Picture in PictureSerial Control Interface OperationFormat Functional Execution CommandStatus Read Command KY2AL