Appendix
| – Filter is out of scroll. Replace the filter cartridge with a new one promptly. (See | |
| pages | |
appears on the screen |
| |
| – Adjust the focus of the projector. | |
| – Check Projection Lens to see if it needs cleaning. | |
The image is out of | Note: Moving the projector from a cool temperature location to a warm temperature | |
location may result in moisture condensation on Projection Lens. In such | ||
focus.. | ||
cases, leave the projector OFF and wait until condensation evaporates. | ||
| ||
| ||
| and partial imperfect focus. | |
| – Check if Contrast or Brightness is adjusted properly. (See pages 40, 48) | |
The image is not | – Check if Image level is selected properly. (See pages 39, 47) | |
– Check the Lamp control function. ( See “Setting” section on page 61) | ||
bright enough.. | ||
– Check the LAMP REPLACE indicator. If it lights, the end of lamp life is approaching. | ||
| ||
| Replace the lamp with a new one promptly. (See page 74) | |
The color is strange.. | – Check the Input signal, color system, video system, or computer system mode. | |
– Adjust the Image Level properly. (See pages 40, 47) | ||
| ||
The image is Left/ | – Check the Ceiling / Rear function. (See pages 45, 52) | |
Right reversed.. | ||
| ||
The image is Top/ | – Check the Ceiling function. (See pages 45, 52) | |
Bottom reversed.. | ||
| ||
The image is distorted | – Check PC adjust Menu or Screen Menu and adjust them. | |
or runs off.. |
| |
Auto PC adjustment | – Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p, | |
function does not | 720p, 480i, 575i, 1035i, 1080i or 1080p is selected or when the digital signal is input | |
work. | into HDMI or | |
Some displays are |
| |
not seen during the | – Check the Display function. (see page 54) | |
operation.. |
| |
The setting does not | – Make sure you selected Store after adjusting settings. Some settings cannot be | |
remain after turning | ||
stored if not registered with Store function. | ||
off power.. | ||
| ||
Power management | – Power management function cannot work while Freeze function is running or the | |
function does not | ||
shutter is closed. | ||
work.. | ||
| ||
Image disappears | – Check the power management function in the Setting. The power management is set | |
automatically.. | to On at the factory. | |
Capture function does | – Check the connection to see if there is signal. | |
– Capture function is not available when the Picture in Picture function is set to User1- | ||
not work.. | 5. | |
| ||
Some menus cannot | – Each of the Video Input and Computer Input has a limit on selectable menus. | |
be selected.. | ||
| ||
The shutter does not | – Check "Protection" or "Release key" of the Shutter function. (See p.67) | |
work.. |
|
79