Sanyo PLC-HP7000L Appendix List of Picture in Picture, Serial Control Interface, Operation, Note

Appendix

List of Picture in Picture

o : Picture in Picture combinations are enabled.

x : Picture in Picture combinations are disabled.

Note:

•When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.

•Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered or images may not be displayed on the Main/Sub picture.

<Display resolution is lowered when;>

•Inputting PC analog signals: Between 100-162 MHz

<Images are not displayed and X mark appears when;>

•Inputting PC analog signals: More than 162 MHz

•Inputting PC digital signals: More than 100 MHz

•Inputting AV digital signals: 1080p

<Picture in Picture is disabled when;>

• Inputting signal formats: WUXGA 1, WXGA+2, UXGA 2, UXGA 3, UXGA4, D-1080p

Serial Control Interface

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial port.

Operation

1Connect a RS-232C serial cross cable to CONTROL PORT on the projector and serial port on the PC. (See p.19)

2Launch a communication software provided with PC and setup the communication condition as follows:

Baud rate : 9600 / 19200 bps

Parity check	: none
Stop bit	: 1
Flow control	: none
Data bit	: 8

3Type the command for controlling the projector and then enter the "Enter" key.

Example

When you want to change the input to INPUT 2, Type 'C' '0' '6' 'Enter'.

Note:

The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate).

Note:

Enter with ASCII 64-byte capital characters and one-byte characters.

95