Setting up
Inserting an SD card and USB memory
When using the projector with a wireless LAN please insert the included wireless network card. When using a commercial SD memory card in order to view images insert the SD memory card in the same manner. And when using a commercial USB memory in order to view images insert the USB memory to the AUX I/O port. See the “User's Manual - Network Function” for information on using either type of
card.
|
| Wireless |
| ||
|
| communication | |||
|
|
| RGB OUT |
| LAN |
Wireless |
|
|
|
|
|
communication |
|
|
| USB |
|
Insert the Wireless |
|
|
|
| |
|
|
| memory | ||
network card |
|
|
|
|
|
|
|
| AUX I/O | LAN |
|
|
|
|
|
| |
|
|
| DC 5V 0.5A |
|
|
|
| RGB | RGB1 | RGB2 | |
|
| OUT |
|
|
|
AUDIO IN 1 | VIDEO | Y | CB/PB |
|
|
|
|
|
| ||
AUDIO IN 2 |
|
|
|
|
|
|
|
| CR/PR |
| |
|
| R L | R L | AUDIO | REMOTE |
| CONTROL | ||||
|
| AUDIO IN 3 | AUDIO IN 4 | OUT | CONTROL |
AUX I/O port
SD card slot
Angled corner
1. Make sure the projector’s power switch is OFF.
2. Remove the SD card slot cover. Pull the cover forward, pushing slightly its edge up, to remove it from the projector.
3. Insert the SD card. Slowly insert the SD card completely into the SD card slot. Make sure the angled corner of the SD card is facing the right side (AUX
I/O port side) of the projector while inserting.
4. Replace the SD card slot cover. Replace the cover by reversing the procedure used when removing the cover.
NOTE • When using the projector with a wired LAN, please remove the wireless network card.
•Before removing the SD card or USB memory, be sure to perform the REMOVE procedure using the SERVICE menu under the MIU menu (58). IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co- llocated or operating in conjunction with any other antenna or transmitter.
12