Hitachi CP-X608 user manual Option Menu, Turn on  Turn OFF, Auto Search, Auto on

OPTION Menu

OPTION Menu

From the OPTION menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons on the projector or remote control, and press the ► cursor button on the projector or remote control, or ENTER button on the remote control to execute the item, except for the items LAMP TIME and FILTER TIME. Then perform it according to the following table.

/'07=4)$?	5'.'%6
2+%674'	#7615'#4%*67401((
+/#)'	#761-';5610'67401((
+0276	#7611067401((
5'672	#7611((OKP
#7&+1	.#/26+/'J
5%4''0	(+.6'46+/'J
126+10	/;$76610
/+7	5'48+%'
'#5;/'07	5'%74+6;

Item

Description

	Using the ▲/▼ buttons turns on/off the automatic signal search function.
	TURN ON  TURN OFF
	When the TURN ON is selected, detecting no signal automatically cycles
	through input ports in the following order. The search is started from the
AUTO SEARCH	current port. Then when an input is found, the projector will stop searching
	and display the image.
	RGB 1  RGB 2  M1-D  MIU  COMPONENT  S-VIDEO  VIDEO
	• The MIU input is skipped, as long as no image is sent from PC on
	the “Live Mode” (54).
	Using the ▲/▼ buttons turns on/off the automatic keystone function.
	TURN ON  TURN OFF
	TURN ON : Automatic keystone distortion correction will be
	executed whenever changing the slant of the projector.
AUTO	TURN OFF : This function is disabled. Please execute the AUTO
KEYSTONE	KEYSTONE EXECUTE in the SETUP Menu for automatic
	keystone distortion correction.
	• When the projector is suspended from the ceiling this feature will
	not function properly so select the TURN OFF.
	• This function will be unavailable when the Transition Detector is
	on (52).
	Using the ▲/▼ buttons turns on/off the AUTO ON function.
	TURN ON  TURN OFF
	When AUTO ON is set to TURN ON, the projector’s lamp will only
AUTO ON	be automatically turned on when the Power switch is turned on if
	the power was turned off using the Power switch the last time the
	projector was turned off.
	• After turning the lamp on by the AUTO ON function, if neither input nor
	operation is detected for about 30 minutes, the projector is turned off, even
	though the AUTO OFF function (44) is disabled.

(continued on next page)

43