Kodak i600 Series manual Stop/Pause and Start/Resume buttons

Page 12

7 Stop/Pause and Start/Resume buttons —

Stop/Pause (white with red triangle) button: press once to temporarily pause scanning (the green button can then use used to resume scanning). Press twice to stop scanning (end of job).

Start/Resume (green) button: to start scanning.

8LEDs— illuminate or flash from top to bottom as follows:

Illuminates when the power is turned on and the scanner is idle. This indicator will flash if the scanner is in “sleep” or lamp saver mode.

illuminates when the scanner is enabled and/or scanning, and flashes when the scanner is powering up.

flashes when a document has jammed in the transport or when a multi-feed has been detected. Illuminates when a user- correctable error has been detected.

Illuminates when you need to call Service.

Refer to Chapter 6, Troubleshooting, for complete descriptions of the LED indicators.

9Power switch — press the power switch on (I) or off (O) as required.

10Exit deflector (optional) — aids in document stacking.

11Paper Present Sensor — detects the presence of documents in the elevator tray.

12* Height Adjustment Wire — located underneath the output tray (not shown in photo), this wire can be pulled out to raise the front of the output tray.

2-4	A-61500 April 2007

Image 12

Contents Page Contents Appendix a Introduction Scanner models Optional accessories Scanner features Speed/capacity Throughput Supporting documentationSafety information User precautionsEnvironmental InformationEMC statements Acoustic emission Getting Started Making connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Using the Scanner Turning the scanner on and offStarting and stopping scanning Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Adjusting the back of the output tray Locking the side guidesForward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeCalibrating the scanner Image calibrationSelect Kodak Scanner Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeChanging print positions Page Replacing the ink cartridge Page Replacing the blotter strips Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover April Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the pre Separation padReplacing the imaging GuidesTroubleshooting Indicator lightsScanner is in sleep mode and has detected a hardware error Accessing the Operator Log Page Page Message listing ID#April Informational message. The pod was closed Informational message. Scanner paused April Numerical message ListingApril Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/Speed