Operator Log Message | ID# | Description/Action |
23 | A | |
|
| scanner was set to the Display only mode. |
|
| • Check the host monitor to see if there are any overlapped |
|
| documents that may need to be rescanned. |
|
| This condition may be caused by poor document separation. |
|
| • Replace the separation roller tires and |
|
| See Chapter 5, Maintenance for procedures. |
334 | A | |
|
| the job has ended. |
|
| • |
|
| are any overlapped documents that may need to be |
|
| rescanned. |
|
| This condition may be caused by poor document separation. |
|
| • Replace the separation roller tires and |
|
| See Chapter 5, Maintenance for procedures. |
247 | A document was measured which exceeded the configured | |
|
| maximum allowable length in the Display only mode. This may |
|
| be due to a document overlap. |
|
| • Check the host monitor to see if there are any overlapped |
|
| documents that may need to be rescanned. |
|
| This condition may be caused by poor document separation. |
|
| • Replace the separation roller tires and |
|
| See Chapter 5, Maintenance for procedures. |
248 | A document was measured which exceeded the configured | |
|
| maximum allowable length and the transport has stopped. This |
|
| may be due to a document overlap. |
|
| • |
|
| are any overlapped documents that may need to be |
|
| rescanned. |
|
| This condition may be caused by poor document separation. |
|
| • Replace the separation roller tires and |
|
| See Chapter 5, Maintenance for procedures. |
No paper in elevator tray | 260 | The scanner was started with an empty elevator tray. |
|
| • Place the documents you want to scan in the elevator tray and |
|
| try again. |
Page on demand complete | 337 | Informational message. The scanner has completed scanning |
|
| the requested number of documents. |
|
|
|
Parameter settings conflicting | 4 | The image processing values sent by the host are invalid. |
|
| • Check the job settings for illegal combinations. Refer to the |
|
| Image Processing Guide for valid parameter values. |
|
|
|
Pod door closed | 213 | Informational message. The pod was closed. |
|
|
|
Pod door opened | 212 | Informational message. The pod is not closed completely. |
|
|
|
Power on | 20 | Informational message. The scanner has completed its |
|
| after |
|
|
|
|