Kodak i600 Series manual Changing print positions

Page 31

Changing print positions

The horizontal print position can be changed manually.

Changing the front	1. Remove the output tray.
horizontal print position

2. Open the print access cover.

There are 12 horizontal print positions. These positions are visible by a small detent on the printer rail.

A-61500 April 2007

4-3

Image 31

Contents Page Contents Appendix a Introduction Scanner models Optional accessories Scanner features Supporting documentation Speed/capacity ThroughputInformation Safety informationUser precautions EnvironmentalAcoustic emission EMC statementsGetting Started Making connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Turning the scanner on and off Using the ScannerStarting and stopping scanning Manually ending scanning Automatically pausing and resuming the scannerMaterials Document preparationAdjusting the side guides and end stop Locking the side guides Adjusting the back of the output trayForward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Press Start/Resume Manual feedingImage calibration Calibrating the scannerSelect Kodak Scanner Page Click Calibrate Page Overview Enhanced PrinterFont size Printer specificationsChanging print positions Page Replacing the ink cartridge Page Replacing the blotter strips Page Maintenance Cleaning frequency chart Cleaning tools and materials Ordering parts Supplies and accessoriesOpening the pod Cleaning the output tray and elevator areaCleaning the separation roller tires Cleaning the drive rollersCleaning the feed module tires Close the printer access cover April Cleaning the scanner transport area Cleaning the imaging guides Cleaning the background stripsPage Running a transport cleaning sheet Replacing the feed module or feed module tires Replacement proceduresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Guides Replacing the preSeparation pad Replacing the imagingIndicator lights TroubleshootingScanner is in sleep mode and has detected a hardware error Accessing the Operator Log Page Page ID# Message listingApril Informational message. The pod was closed Informational message. Scanner paused April Listing Numerical messageApril Problem Possible Solution Problem solvingMaintenance Appendix a Accessories Scanner Type/Speed Appendix B Specifications