Kodak i600 Series manual

Page 32

3.The printer carrier slides easily along the rail. There is a small arrow on the green printer carrier. Slide the printer carrier to the desired position aligning the arrow with the detent position on the rail.

4.Close the printer access cover.

5.Reinstall the output tray.

NOTE: Printing automatically stops approximately ½-inch (1.27 cm) from the trailing edge of the document, even if the information has not been completely printed.

4-4	A-61500 April 2007

Image 32

Contents Page Contents Appendix a Introduction Scanner models Optional accessories Scanner features Speed/capacity Throughput Supporting documentationSafety information User precautionsEnvironmental InformationEMC statements Acoustic emissionGetting Started Making connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Starting and stopping scanning Using the ScannerTurning the scanner on and off Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Adjusting the back of the output tray Locking the side guidesForward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeSelect Kodak Scanner Calibrating the scannerImage calibration Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeChanging print positions Page Replacing the ink cartridge Page Replacing the blotter strips Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover April Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the pre Separation padReplacing the imaging GuidesTroubleshooting Indicator lightsScanner is in sleep mode and has detected a hardware error Accessing the Operator Log Page Page Message listing ID#April Informational message. The pod was closed Informational message. Scanner paused April Numerical message ListingApril Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/Speed