Kodak i600 Series manual Informational message. Scanner paused

Page 62

Operator Log Message

ID#

Description/Action

Print head not installed

282

An attempt was made to use the Document Printer without a

 

 

print head installed.

 

 

• Be sure the cable is properly connected to the ink cartridge

 

 

carrier and the ink cartridge is installed in the print head

 

 

assembly. See Chapter 4, The Document Printer for more

 

 

information.

 

 

NOTE:The ink cartridge must be installed before turning on the

 

 

scanner.

Printer bitmap font in use

132

Informational message. At the time of this message, a bitmap

 

 

printer font file was found on the Flash disk and is being used in

 

 

lieu of the static font information built in the scanner software.

 

 

 

Printer count exceeded maximum

258

The printer count is larger than the maximum configured value.

set value

 

• Reconfigure the scanner to allow a larger value for the printer

 

 

count. Refeed the document set.

 

 

Documents passed through the transport but no images were

 

 

created.

 

 

• Refeed these documents and verify that the images have been

 

 

captured.

 

 

 

Refeed document set

52, 137,

Documents passed through the transport but no images were

 

153, 537,

created.

 

553, 937,

• Refeed these documents and verify that the images have been

 

953

captured.

 

 

 

Scanner failed to enable

5

• The previous error condition has not been corrected. For

 

 

example, there could be a document jam that has not been

 

 

completely cleared.

 

 

• Incomplete or conflicting image processing parameters. For

 

 

example, selecting Error Diffusion for binarization and Noise

 

 

Filter together.

 

 

• See other log entries for the actual condition.

 

 

 

Scanner failed initialization

6

This error could occur during scanner power-up.

 

 

• Power-down the scanner, then power down the PC. Wait a few

 

 

seconds and then power the PC back up, then power up the

 

 

scanner.

 

 

• If the problem persists, call Service.

 

 

 

Scanner has lost synchronization

131, 531,

An internal scanner sync condition has occurred.

 

931

• Clear the documents and power cycle the scanner. Rerun the

 

 

job.

 

 

• If the problem persists, call Service.

 

 

 

Scanner interface cable reset

319

The scanner interface cable has reset. Some device on the

 

 

FireWire bus was unplugged/plugged in.

 

 

• Check that all FireWire connectors are securely fastened.

 

 

 

Scanner paused for rotation or

63

Informational message. Scanner paused.

host processing

 

• Slow host PC may not be able to keep up with the scanner.

 

 

• Auto rotation may be causing the scanner to slow down.

 

 

 

Transport timeout

336

Informational message. The transport was turned off due to

 

 

inactivity.

Ultrasonics calibration failed

333

The Ultrasonics calibration failed.

 

 

• Power up the scanner and try to calibrate again. Be sure you

 

 

are using the correct ultrasonics calibration target. See

 

 

Chapter 3, “Calibrating the scanner”.

A-61500 April 2007

6-9

Page 61 Page 63
Image 62
Page 61 Page 63
Contents Page Contents Appendix a Introduction Scanner models Optional accessories Scanner features Speed/capacity Throughput Supporting documentationEnvironmental Safety informationUser precautions InformationEMC statements Acoustic emissionGetting Started Making connections Scanner components Front view Stop/Pause and Start/Resume buttons Internal components Rear view Starting and stopping scanning Using the ScannerTurning the scanner on and off Automatically pausing and resuming the scanner Manually ending scanningDocument preparation MaterialsAdjusting the side guides and end stop Adjusting the back of the output tray Locking the side guidesForward detent positions Exit deflector Adjusting the optional short document tray Automatic feeding Continuous feeding Manual feeding Press Start/ResumeSelect Kodak Scanner Calibrating the scannerImage calibration Page Click Calibrate Page Enhanced Printer OverviewPrinter specifications Font sizeChanging print positions Page Replacing the ink cartridge Page Replacing the blotter strips Page Maintenance Cleaning frequency chart Cleaning tools and materials Supplies and accessories Ordering partsCleaning the output tray and elevator area Opening the podCleaning the drive rollers Cleaning the separation roller tiresCleaning the feed module tires Close the printer access cover April Cleaning the scanner transport area Cleaning the background strips Cleaning the imaging guidesPage Running a transport cleaning sheet Replacement procedures Replacing the feed module or feed module tiresPage Locking tab Locking tab Slot Replacing the separation roller or separation roller tires Replacing the imaging Replacing the preSeparation pad GuidesTroubleshooting Indicator lightsScanner is in sleep mode and has detected a hardware error Accessing the Operator Log Page Page Message listing ID#April Informational message. The pod was closed Informational message. Scanner paused April Numerical message ListingApril Problem solving Problem Possible SolutionMaintenance Appendix a Accessories Appendix B Specifications Scanner Type/Speed

i600 Series specifications

The Kodak i600 Series is a range of high-performance document scanners designed to meet the needs of businesses requiring reliable and efficient document management solutions. Renowned for its durability and speed, the i600 Series excels in processing large volumes of documents, making it an ideal choice for busy offices and organizations.

One of the standout features of the Kodak i600 Series is its exceptional scanning speed. Equipped to handle up to 130 pages per minute, the scanners significantly reduce the time spent on document processing. This high throughput ensures that even the busiest work environments can maintain productivity without interruption. The automatic document feeder (ADF) can hold up to 500 sheets, allowing for bulk scanning without the need for constant supervision.

The i600 Series utilizes advanced imaging technologies to deliver superior image quality. With its Perfect Page technology, the scanners enhance the clarity and readability of documents irrespective of their original condition. This feature optimizes the scanned images by automatically adjusting brightness, contrast, and color balance. Additionally, the scanners support a range of document types, from large-format pages to mixed-sized documents, ensuring versatility in handling various office materials.

Seamless integration with existing workflows is another hallmark of the Kodak i600 Series. The scanners are compatible with a variety of software applications, enabling users to easily incorporate them into their document management systems. Furthermore, the series supports advanced file formats such as PDF and TIFF, thereby facilitating efficient storage and retrieval processes.

Security is also a top priority for organizations using the i600 Series. The scanners come equipped with features that allow for secure document handling, including user authentication and encryption options. This ensures that sensitive information remains protected throughout the scanning process.

Additionally, the Kodak i600 Series is designed with user-friendliness in mind. The intuitive touchscreen interface simplifies navigation and operation, allowing users to perform tasks with ease. Maintenance is also straightforward, with self-cleaning options that promote longevity and minimize downtime.

In summary, the Kodak i600 Series is a robust and versatile document scanning solution that combines speed, image quality, and security. Its advanced features and user-friendly design make it an excellent choice for businesses looking to enhance their document management capabilities. By streamlining workflows and improving efficiency, the i600 Series helps organizations achieve their goals while effectively managing their critical information.
Top Page Image Contents