Kodak i30 / i40 manual Defining the Scan area

Page 67

Energy Saving features of

Energy Star allows you to set the amount of time the scanner will

the scanner

remain inactive before the scanner goes into an idle state (sleep mode).

 

Choices are: 0 to 60 minutes.

Transport timeout

This feature allows you to set a transport timeout value. This value is

 

the amount of time the scanner will wait after the last document enters

 

the transport before the transport timeout action is taken. You can

 

specify a time delay setting from 1 to 300 seconds. The default is 10

 

seconds.

Blank image detection

Use the slider bar to specify the image size (KB), below which an image

 

is determined to be blank. Images with sizes less than the size number

 

you select will not be created. If you use this option, you must specify a

 

blank image size for each image type (Bi-tonal, Gray and Color) you

 

want to delete. The default for this option is None, which means that

 

you will keep all images.

Defining the Scan area

The Scan Area dialog box is only available for images when the

 

Cropping option selected on the Scanner Settings dialog box is either

 

Fixed to Transport or Relative to Document cropping.

 

To access the Scan Area dialog box, select Area on the ISIS Scanner

 

Settings window.

NOTE: Select the side and image to be defined by highlighting Front Color (Grayscale), Front Binary, Back Color (Grayscale), or Back Binary as appropriate based on the cropping option selected for each of these in the Scanner Settings dialog box. The scan areas defined for all camera selections are independent.

64

A-61512 May 2006

Image 67
Contents User’s Guide Contents Maintenance Introduction Scanner features Safety and regulatory Safety informationAgency approvals United States EMC statementsJapan European Union Power systemAcoustic emission ConnectionWhat’s in the box System requirements Getting StartedAttaching the input tray Select Install Scanner Software Installing the Kodak Driver SoftwareAttaching the output tray and special document feeder Page Page Select USB Test United States Canada China power cord Cable Connecting the USBPage Software Installing applicationFront view Scanner componentsBack view Inside viewTurning the scanner on and off Adjusting the input and output traysFront-feed minimum/center alignment 6.35 x 5.08 cm 2.5 x 2.0 Start and stop scanningVerifying your scanner installation Page Page Application software Viewing test imagesManager Configuring functionsPage Configuring Readiris InstallingSelect Scanner Model Page Numbers Assigning functionUsing function numbers Scanning your documents Scanning documents using the special document feeder Common terms OverviewBi-tonal or Binary black-and-white Color Making cameraSelections Example 1 scanning a two-sided color document both sidesStarting the Scan Validation Tool Scan Validation Tool dialog box Kodak Scanner Properties dialog box Using the Twain DatasourceButtons on the Kodak Scanner Properties dialog box Imaging tab Page Disabled No Noise Filter Used Dpi 80 Threshold 200 dpi Contrast 100 Page Page Cropping values Paper tabPage 61512 May Page Better, Best, Superior Dropout tabRemove Red, Remove Green, Remove Blue Multifeed tab Options tab Tool, via the Twain Datasource Setup tabInfo tab Box Using the Isis DriverScanner Settings dialog Settings dialog boxCamera Settings area Page Page Fixed thresholding ATP disabled Dpi 80 Threshold 20 Contrast Dpi 80 Threshold 100 Contrast More Scanner Settings dialog box Image Control options Black on White polarity White on Black polarity Color Dropout options Options Scanner ControlDialog box Multi-Feed DetectionDefining the Scan area Area Maintenance Cleaning the feed module Cleaning the rollersCleaning the calibration area Module Replacing the feedSupplies and consumables Clearing a document jam Indicator lights and error codesProblem Possible Solution Problem solving61512 May Scanner not working Page Page Connection Testing for a USB\program files\Kodak\Document Imaging\usbtst.exe Your operating system only supports USB SolutionsUSB will not work You do not need to install any additional USB cardsAppendix a Specifications Eastman Kodak Company