Default when you select Default, the values will be reset to the factory defaults.
OK saves the values set on all dialog boxes.
Cancel closes the dialog box without saving any changes.
Camera Settings area
The selections in the Camera area list the available sides (front and back) of an image where you can define individual image processing values. Options include: Front Color, Front Binary, Back Color and Back Binary. For detailed information about Camera selection, see the section entitled, “Making camera selections” earlier in Chapter 4.
On the Kodak i40 Scanner there is a separate camera for each side of the document being scanned. The Kodak scanner drivers allow you to control the camera settings independently. Some settings apply only to binary
When starting the configuration process, use the steps below as a guide:
1.Check the images you wish to capture (Enable camera settings).
2.Select the order to transfer the images (Color First or Binary First).
3.Configure each image by highlighting it (Configure).
Enable camera settings select the desired checkbox to enable the Front Color, Front Binary, Back Color or Back Binary settings as desired. This indicates the images you wish to capture and transfer to the host PC. (It is possible to capture only rear images.) Enable your selection by putting a checkmark in the desired box.
Color First/Binary First define the transfer order by selecting the Color First or Binary First radio button. This determines which image is transferred to the host PC first when using simultaneous output scanning. For example, if you are scanning front color and front binary and you select Binary First the scanner will return the front binary image, then the front color image.
54 |
|