Kodak A-61167 manual

Page 19

4. Plug the power cord into a power outlet.

NOTE: Make sure that the power outlet is located within 1.52 metres (5 feet) of the scanner and is easily accessible.

5.Press the side labeled “I” on the power switch to power up the scanner.

After you power up the scanner, the red and green indicator lights will illuminate. After approximately one minute, both lights go out. When the green indicator light comes back on, the scanner is installed and ready to begin scanning. However, the host computer may require a few more seconds to detect the scanner.

For best calibration and scanning results, allow the scanner lamps to warm up for at least three minutes.

•If you are installing the scanner on a computer that is running Windows 2000, the following screen may appear.

Select Yes. Kodak has successfully tested the i200 Series Scanners with Windows 2000.

Your scanner is now installed.

•If you are installing the scanner on a computer that is running Windows XP, the following screen may appear.

A-61167 April 2005

15

Image 19

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresSpeed/Capacity Throughput Paper transport featuresImage quality features MaintenanceOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system Taiwan EMC statementsUnited States JapanSite specifications Installing the ScannerSystem requirements Scanner components Unpacking the scanner Registering your scannerFront Side RearInternal Making connections Power setup Page Page Tray extenders and side guides Page Starting and stopping scanning Automatic feeding Using the ScannerContinuous feeding Damaged documents Manual feedingLong Paper mode Additional featuresSpecial Document mode IThresholding Perfect Page withToggle patch Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides Cleaning the paper path Replacing partsCAT No Click Calibrate Indicator lights TroubleshootingLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Dimensions Power SourceScanner Dimensions Scanner WeightAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Installing the dockable flatbed Contents of the dockable flatbed kit Flatbed specificationsAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Installing memory in the scanner Appendix E Installing Optional MemoryScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company