Kodak A-61167 manual Cleaning the imaging guides

Page 31

Cleaning the imaging guides

3. Wipe the upper and lower transport areas with a roller cleaning pad.

4.Dry the transport area with a dry Staticide Wipe.

5.Push against the raised edge on the left side of the rear roller cover and pull the cover up and out to remove it.

Rear roller cover

6.Remove any dust or debris under the rear roller cover.

7.Re-install the rear roller cover.

8.Go to the next section to clean the imaging guides.

Clean the exposed (top side) surfaces of the imaging guides. You do not need to remove the imaging guides for cleaning.

1. Wipe the upper and lower imaging guides with a Staticide Wipe.

2.Dry the imaging guides with a dry Staticide Wipe.

3.Lower the scanner door and press it down firmly until it latches into place.

4.Go to the next section to clean the paper path.

A-61167 April 2005

27

Image 31

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresSpeed/Capacity Throughput Paper transport featuresImage quality features MaintenanceOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system Taiwan EMC statementsUnited States JapanSite specifications Installing the ScannerSystem requirements Scanner components Unpacking the scanner Registering your scannerFront Side RearInternal Making connections Power setup Page Page Tray extenders and side guides Page Starting and stopping scanning Automatic feeding Using the ScannerContinuous feeding Damaged documents Manual feedingLong Paper mode Additional featuresSpecial Document mode IThresholding Perfect Page withToggle patch Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides Cleaning the paper path Replacing partsCAT No Click Calibrate Indicator lights TroubleshootingLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Dimensions Power SourceScanner Dimensions Scanner WeightAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Installing the dockable flatbed Contents of the dockable flatbed kit Flatbed specificationsAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Installing memory in the scanner Appendix E Installing Optional MemoryScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company