Kodak A-61167 manual

Page 51

6. Remove the ink cartridge from its packaging.

NOTE: Detailed information about installing ink cartridges may be found later in this chapter.

7.Place the ink cartridge in the ink cartridge carrier.

8.Lower the locking bar around the ink cartridge.

9.Push the connector on the imprinter cable firmly into the ink cartridge carrier.

10. Slide the ink cartridge carrier into the desired position.

NOTE: Detailed information about setting the imprinter position may be found later in this chapter.

11.Replace the imprinter access door.

12.Re-attach the output tray.

13.Go to the next section to install the ink blotter strips in the scanner.

A-61167 April 2005

C-9

Image 51

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresSpeed/Capacity Throughput Paper transport featuresImage quality features MaintenanceOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system Taiwan EMC statementsUnited States JapanSite specifications Installing the ScannerSystem requirements Unpacking the scanner Registering your scanner Scanner componentsFront Rear SideInternal Making connections Power setup Page Page Tray extenders and side guides Page Using the Scanner Starting and stopping scanning Automatic feedingContinuous feeding Damaged documents Manual feedingAdditional features Long Paper modeSpecial Document mode Perfect Page with IThresholdingToggle patch Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides Replacing parts Cleaning the paper pathCAT No Click Calibrate Troubleshooting Indicator lightsLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Dimensions Power SourceScanner Dimensions Scanner WeightAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Contents of the dockable flatbed kit Flatbed specifications Installing the dockable flatbedAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Appendix E Installing Optional Memory Installing memory in the scannerScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company