Maintenance
Cleaning the scanner
The scanner will collect dust and other debris during routine scanning. For optimal scanner performance, follow the detailed cleaning instructions
in this section and clean the feed module tires, separator module tires, imaging guides, transport area, and paper path at least once per week. Clean the scanner and paper path daily if you are scanning carbonless paper or newsprint, or if you are using the imprinter.
Use only these cleaning materials:
Item | CAT No. |
|
|
Kodak Digital Science Roller Cleaning Pads (24) | 853 5981 |
|
|
Staticide Wipes for Kodak Scanners (144) | 896 5519 |
|
|
Kodak Digital Science Transport Cleaning Sheets (50) | 169 0783 |
|
|
IMPORTANT: Staticide Wipes contain isopropanol which can cause eye irritation and dry skin. Wash your hands with soap and water after performing maintenance procedures. Refer to the Material Data Safety Sheet (MSDS) for more information. The MSDS is available on the Kodak web site at www.kodak.com/go/MSDS.
Allow all tires to dry completely before using the scanner.
NOTES: The use of any other cleaning materials could damage your scanner. Use fresh cleaning material unless otherwise indicated.
In addition to the recommended cleaning supplies, you may use a vacuum cleaner to remove debris from the scanner.
Some debris from the rubber tires on the feed module and separator module is normal. Tire debris does not always mean that the tires are worn or damaged. After cleaning, inspect the tires for wear and replace the separator module or feed module if necessary.
To order cleaning supplies, refer to Appendix B, Supplies and Accessories.
23 |