Kodak A-61167 manual

Page 30

3. Manually rotate and wipe the feed module s with a roller cleaning pad.

4.Inspect the feed module.

If the feed module tires show signs of wear or damage, replace the tires or the feed module.

5.Remove any dust or debris from the tray area under the feed module and the front roller cover.

6.Insert the feed module by aligning the pins and pushing it toward the right to fit it into position.

7.Re-install the front roller cover.

8.Go to the next section to clean the drive rollers and transport area.

Cleaning the drive rollers 1. Manually rotate and wipe the drive rollers with a roller cleaning pad. and transport area

2. Clean any dust or debris in the slots around the drive rollers.

26	A-61167 April 2005

Image 30

Contents User’s Guide Contents Using the Scanner TroubleshootingAppendix D Kodak i200 Series Dockable Flatbed Scanner features IntroductionMaintenance Paper transport featuresImage quality features Speed/Capacity ThroughputOptional accessories Preparing documents for scanning Recommended documents Safety information User precautionsSafety and regulatory agency approvals Environmental information Acoustic emission Power system Japan EMC statementsUnited States TaiwanInstalling the Scanner Site specificationsSystem requirements Unpacking the scanner Registering your scanner Scanner componentsFront Rear SideInternal Making connections Power setup Page Page Tray extenders and side guides Page Using the Scanner Starting and stopping scanning Automatic feedingContinuous feeding Manual feeding Damaged documentsAdditional features Long Paper modeSpecial Document mode Perfect Page with IThresholdingToggle patch Maintenance Cleaning the scannerCleaning the separator module Front roller cover Page Cleaning the imaging guides Replacing parts Cleaning the paper pathCAT No Click Calibrate Troubleshooting Indicator lightsLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem solving Problem Possible SolutionProblem Possible Solution Transporting the scanner Appendix a Specifications Scanner Weight Power SourceScanner Dimensions DimensionsAppendix B Supplies and Accessories Contents of the imprinter kit Appendix C Kodak i200 Series ImprinterInstalling the imprinter Removing the circuit board coverAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Print characters Printable Character SetImprinter specifications Contents of the dockable flatbed kit Flatbed specifications Installing the dockable flatbedAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Using the flatbed Book scanningClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Appendix E Installing Optional Memory Installing memory in the scannerScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company