Kodak A-61167 manual Imprinter maintenance

Page 55

Imprinter maintenance	The ink cartridges, ink blotter strips, and ink cartridge carrier used in the
	imprinter will need replacing occasionally.
Imprinting problems	If you are having problems imprinting on scanned documents:
	• Verify that the ink cartridge is not empty. The ink bladder inside the cartridge
	is flat when it is empty.
	• Make sure that the ink cartridge is properly installed in the imprinter.
	• Make sure that the ink cartridge is located in the correct position
	for imprinting.
	• Make sure that the ink cartridge carrier is properly seated in its
	positioning slot.
	• Verify that all imprinter connectors are securely fastened and that the
	imprinter cables are not folded or creased.
Expected life of imprinter	• Imprinter ink cartridge: approximately 750,000 non-bold characters
components	per cartridge
	• Ink blotter strips: replace as necessary when soiled
	• Ink cartridge carrier: approximately 500,000 pages
When the imprinter	When the imprinter is not being used, place the ink cartridge on its side so that
is not in use	ink does not drip down on the blotter strips.
Replacing an ink cartridge	Refer to “Installing an ink cartridge” in this chapter for information about
	replacing an empty ink cartridge.
	Purchase ink cartridges from an office supply retailer near you.

A-61167 April 2005

C-13

Image 55

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresSpeed/Capacity Throughput Paper transport featuresImage quality features MaintenanceOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system Taiwan EMC statementsUnited States JapanSite specifications Installing the ScannerSystem requirements Scanner components Unpacking the scanner Registering your scannerFront Side RearInternal Making connections Power setup Page Page Tray extenders and side guides Page Starting and stopping scanning Automatic feeding Using the ScannerContinuous feeding Damaged documents Manual feedingLong Paper mode Additional featuresSpecial Document mode IThresholding Perfect Page withToggle patch Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides Cleaning the paper path Replacing partsCAT No Click Calibrate Indicator lights TroubleshootingLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Dimensions Power SourceScanner Dimensions Scanner WeightAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Installing the dockable flatbed Contents of the dockable flatbed kit Flatbed specificationsAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Installing memory in the scanner Appendix E Installing Optional MemoryScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company