Kodak A-61167 manual Installing the imprinter, Removing the circuit board cover

Page 44

Installing the imprinter

Removing the circuit board cover

1.Make sure that the scanner is powered down and there are no documents in the feeder area.

2.Disconnect the power cord from the back of the scanner.

3.Disconnect the IEEE-1394 (FireWire) cable from the IEEE-1394 port on the back of the scanner.

4.Lift up the scanner door release to unlatch the scanner door.

5.Pull up to open the scanner door.

6.Remove the output tray.

7.Lift up the scanner door release again and open the scanner door past the circuit board cover.

Circuit board cover

8.Use a Phillips-head screwdriver to remove the two screws (one front, one back) that hold the circuit board cover in place.

C-2	A-61167 April 2005

Image 44

Contents User’s Guide Contents Using the Scanner TroubleshootingAppendix D Kodak i200 Series Dockable Flatbed Scanner features IntroductionPaper transport features Image quality featuresMaintenance Speed/Capacity ThroughputOptional accessories Preparing documents for scanning Recommended documents Safety information User precautionsSafety and regulatory agency approvals Environmental information Acoustic emission Power system EMC statements United StatesJapan TaiwanInstalling the Scanner Site specificationsSystem requirements Front Unpacking the scanner Registering your scannerScanner components Internal RearSide Making connections Power setup Page Page Tray extenders and side guides Page Continuous feeding Using the ScannerStarting and stopping scanning Automatic feeding Manual feeding Damaged documentsSpecial Document mode Additional featuresLong Paper mode Toggle patch Perfect Page withIThresholding Maintenance Cleaning the scannerCleaning the separator module Front roller cover Page Cleaning the imaging guides CAT No Replacing partsCleaning the paper path Click Calibrate Lamps Clearing document jams TroubleshootingIndicator lights Adjusting the separator module tension System is not responding Color image quality Problem solving Problem Possible SolutionProblem Possible Solution Transporting the scanner Appendix a Specifications Power Source Scanner DimensionsScanner Weight DimensionsAppendix B Supplies and Accessories Contents of the imprinter kit Appendix C Kodak i200 Series ImprinterInstalling the imprinter Removing the circuit board coverAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Print characters Printable Character SetImprinter specifications Appendix D Kodak i200 Series Dockable Flatbed Contents of the dockable flatbed kit Flatbed specificationsInstalling the dockable flatbed Remove the scanner front panel Using the flatbed Book scanningClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Scanner Model Document Size Basic Memory Total Memory Appendix E Installing Optional MemoryInstalling memory in the scanner Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company