Kodak A-61167 manual Remove the existing memory card from the main control board

Page 69

11. Remove the existing memory card from the main control board.

SODIMM card

12.Plug the new SODIMM card into the main control board.

13.Replace the circuit board cover.

14.Secure the circuit board cover with its two screws.

NOTE: If you removed the optional imprinter cable from the imprinter board, reinstall the cable now. Refer to Appendix C, Kodak i200 Series Imprinter, for information about the imprinter cable.

15.Lower the scanner door and press it down firmly until it latches into place.

16.Re-attach the scanner’s output tray.

17.Re-attach the IEEE-1394 cable to the IEEE-1394 port on the back of the scanner.

18.Re-attach the power cord.

A-61167 April 2005

E-3

Image 69

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresImage quality features Paper transport featuresMaintenance Speed/Capacity ThroughputOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system United States EMC statementsJapan TaiwanSite specifications Installing the ScannerSystem requirements Unpacking the scanner Registering your scanner Scanner componentsFront Rear SideInternal Making connections Power setup Page Page Tray extenders and side guides Page Using the Scanner Starting and stopping scanning Automatic feedingContinuous feeding Damaged documents Manual feedingAdditional features Long Paper modeSpecial Document mode Perfect Page with IThresholdingToggle patch Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides Replacing parts Cleaning the paper pathCAT No Click Calibrate Troubleshooting Indicator lightsLamps Clearing document jams Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Scanner Dimensions Power SourceScanner Weight DimensionsAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Contents of the dockable flatbed kit Flatbed specifications Installing the dockable flatbedAppendix D Kodak i200 Series Dockable Flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Appendix E Installing Optional Memory Installing memory in the scannerScanner Model Document Size Basic Memory Total Memory Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company